ADG5207是一款单芯片CMOS模拟多路复用器，内置8个差分通道。ADG5207根据3位二进制地址线A0、A1和A2所确定的地址，将8路差分输入之一切换至公共差分输出。
The device provides an EN input to enable or disable the device. When this pin is low, the device is disabled and all channels are off. The ultra-low capacitance and charge injection characteristics of these switches make them an ideal solution for data acquisition and sample holding applications that require low burrs and fast settling times. The fast switching speed and high signal bandwidth make these devices suitable for video signal switching applications.
When switched on, the switches conduct the same in both directions, and the input signal range extends to the supply voltage range. Under disconnection conditions, the signal level to reach the supply voltage is blocked.
ADG5207 without VL pins, logic power is generated internally by an on-chip voltage generator.
apply
-
自动测试设备
-
数据采集
-
仪器仪表
-
航空电子
-
电池监控
-
通信系统
Product features:
-
沟道隔离可防止闩锁。
电介质沟道将P沟道与N沟道晶体管分开，保证即使在严重过压状况下，也不会发生闩锁现象。
-
针对低电荷注入、低开关电容和低泄露电流优化的开关设计。
-
ADG5207在连接电源引脚的I/O端口上达到8 kV，在连接I/O端口引脚的I/O端口上达到2 kV，并在所有其他引脚上达到8 kV。
-
双电源供电。
对于双极性模拟信号应用，ADG5207可以采用高达±22 V的双电源供电。
-
单电源供电。
对于单极性模拟信号应用，ADG5207可以采用高达40 V的单轨电源供电。