EE-SPY301

• Product Introduction

 EE-SPY301

Plug photoelectric switch Micro small photoelectric

OMRON's new Omron photoelectric switch pin photoelectric switch EE-SPY301 diffuse type micro small photoelectric switch

Ratings / Performance   Detection method item model Shot type (groove type) Reflective type EE-SPX301、EE-SPX401 EE-SPY301、EE-SPY401EE-SPY302、EE-SPY402 Detection distance 3.6mm (groove width) 5mm (reflectivity 90% 15×15mm white paper)*1 Standard detection objects 1× Opaque body of more than 0.5mm —— Distance should be different Less than 0.05mm 0.2mm (detection distance 3mm, transverse) or less Light source (luminous wavelength) GaAs Infrared Light Emitting Diode (940nm) Display light*2 Light on when light is in (red) Supply voltage DC5~24V±10%, pulsation (p-p) less than 5% Current consumption The average value is less than 15mA, and the front-end value is less than 50mA Control output NPN Voltage Output Load supply voltage DC5~24V, load current 80mA or less, residual voltage 1.0V or less (load current 80mA) Residual voltage 0.4V or less (load current 10mA) Response frequency*3 500Hz or higher 100Hz or higher Use ambient illuminance Illuminance of the light surface Incandescent lamp, sunlight: 3,000 lx or less Ambient temperature When operating: -10~+55°C, when stored: -25~+65°C (without freezing) Ambient humidity When acting: 5~85%RH, when saving: 5~95%RH (non-condensing) Vibration (durable) 10~55Hz repetition amplitude 1.5mm X, Y, Z directions for 2h Impact (Durable) 500m/s2 3 times in each direction of X, Y and Z Protect the structure IEC specification IP50 Connection Connector type (soft brazing is not possible) quality Approx. 2.6g Material enclosure Polycarbonate (PC) *1. If the detection distance is too close to the sensor, it cannot be operated. *2. GaP red LED (maximum luminous wavelength 700nm)*3. The response frequency is determined when the plate shown in the figure below is rotated. (function() {if (typeof desc === 'undefined') {setTimeout(arguments.callee, 100); return; } TShop.renderDesc(desc); })();