Product images are for illustrative purposes only
Product details are welcome upon request

SN65HVD232

Category:Transceiver
Product Name:3.3V Can transceiver
Manufacturers:TI/BB
Production Batch Number:10+
Encapsulation:SOP-8
Stock Status:There is stock
Stock Quantity:9000
Minimum order quantity: 1
Details:

Product introduction

SN65HVD232 3.3V Can 收发器

illustrate

The SN65HVD230, SN65HVD231 and SN65HVD232 controller area network (CAN) transceivers are designed for use with the Texas Instruments TMS320Lx240x; 3.3 - V, DSP with CAN controller, or equivalent device. They are intended to be used in applications employing people in accordance with the physical layer of CAN serial communication with the ISO 11898 standard. Each CAN transceiver design provides differential transmit capability, bus and differential receive speeds up to 1 Mbps CAN controller capability.

Designed to operate in special-harsh environments, these devices feature cross-wire protection, loss of ground and overvoltage protection, overtemperature protection, and a wide common-mode range.

characteristic

Operating, with a 3.3 V supply
Low-power PCA82C250 footprint replacement
The bus/pin ESD protection exceeds 16 kV HBM
The high input impedance allows 120 nodes on the bus
Improvements to control drive output conversion time
Signal quality SN65HVD230 and SN65HVD231
Electrical nodes do not interfere with the bus
Compliant with the requirements of the ISO 11898 standard
Low current standby mode 370 μA SN65HVD230 typical
Low current SN65HVD231 40 nA typical sleep mode
Designed for signal transmission rate^（1）Up to 1 megabit per second (Mbps)
Thermal shutdown protection
Open circuit fail-safe design
Interference-free and brownout protection for hot-swap applications
apply
- Motor control
- Industrial automation
- Base station control and status
- robot
- Car
- UPS control

andSN65HVD232Related ICs are:

Model	Manufacturers	lot number	encapsulation	illustrate
SN65HVD233	TI	10+	SOP-8	3.3V CAN transceiver with standby mode, loop
LMV822-Q1	TI	10+	8MSOP	Automotive dual low voltage RRO op amps
MC33078-EP	TI	10+	8SOIC	Enhanced dual high speed, low noise operational amplifiers
OPA1602	TI	10+	8MSOP, 8SOIC	OPA1602, OPA1604 SoundPlus high-performance, bipolar input audio op amp
OPA1612	TI	08+	8SOIC	1.1nV/√Hz noise, low power precision op amp
SN65HVD231	TI	09+	SOP-8	3.3V CAN transceiver with sleep mode
OPA1642	TI	10+	8MSOP, 8SOIC	Sound-Plus high performance, JFET input audio op amp
SN65HVD230	TI	10+	SOP8	3.3V CAN transceiver with standby mode
OPA2134	TI	08+	8PDIP, 8SOIC	SoundPlus(TM) High performance audio operational amplifier
OPA2300	TI	07+	10MSOP	Low noise, high speed 16-bit precision CMOS operational amplifier

Popular searches

Model	Manufacturers	lot number	encapsulation	illustrate
DZ52-080Z300R024/OH	Hartmann-Lammle	23+	module	Hartmann-Lammle DZ52-080Z300R024/OH
1SVR040011R2500	ABB	2023+	converter	Universal signal converter 110-240VAC 50/60Hz / 100-300VDC
EA12-NO-20-1-31-BD	ROSS ENGINEERING	23+	Relays	EA12-NO-20-1-31-BD High Voltage Relay
EA12-DT-20-1-31-BD	ROSS ENGINEERING	2023+	module	High voltage relays
ABCIRHSE06HC2214PCWF80	AB	2023	connector	Connector Kit ABCIRH Series Connector Assemblies Brand New Original Imported International Stock
AS7C4096A-15JIN	Alliance Memory Inc	23+	SOJ-36	AS7C4096A Series 4-Mbit (512 K x 8) 5 V 15 ns CMOS Static RAM - SOJ-36
US-625AXTLQE	ASAHI KEIKI	2023+	weld	Temperature sensor
V23154D735B110	TE	2023+	Relays	Low Signal Relay - PCB V23154D 735B110
V23154D735F104	TE	23+	Relays	Signal Relays, 250 VDC Contact Voltage, 250 VAC Contact Voltage, 806 mW Coil Power (DC), Printed Circuit Board, PCB-THT, Axicom Cradle Relay N
AZ16-12ZIBI-1747-M20	SCHMERSAL	2023+	switch	Safety gate switch
PW70d(2x10432Ω/83°）	FSG	2023+	potentiometer	PW70D(2*1043Ω 1%/83°）（1700Z04-257.106)
PW70d	FSG	2023+	potentiometer	PW70D(2*1043Ω 1%/83°）（1700Z04-257.106)
S34ML16G202BHI000	Flip Electronics	2051+	63BGA	16 Gb, 3 V, 4-bit ECC, x8 I/O, SLC NAND Flash Memory for Embedded
FRCIR06RGG18-20S-F80-V0-M20-1.5F	ITTVEAM	2023+	connector	Connectors, Circular Connectors, Circular Plugs & Receptacles
HRF-AT4521-FL-TR	Honeywell	10+11+	SMD	RF ATTENUATOR 50OHM 16VQFN
CL1215-02P72ET-U2	Schaltbau	2023+	Contactors	CL1215/02 P 72ET-U2 1, 2 and 3 pole AC and DC NO contactors for voltages up to 1,500 V
CL1115-02P72ET-U2	Schaltbau	2023+	Contactors	1, 2 and 3 pole AC and DC NO contactors for voltages up to 1,500 V
D-U204N-KLGQ	Mors Smitt	2023+	Relays	No magnetic arc blow-out
D-U204N-KLCQ	Mors Smitt	2023+	Relays	No magnetic arc blow-out
MIP30F00830-S1048	Amphenol Positronic	2023+	connector	MIP series connectors

TI/BB brand product recommendation

Model	Manufacturers	lot number	encapsulation	illustrate
SN65HVD10	TI/BB	10+	SOP8	3.3V differential transceiver
SN65HVD61	TI/BB	10+	SOP-14	ControlNet network (trademark) transceiver
TRS232E	TI/BB	09+	TSSOP16	Dual RS-232 driver/receiver with IEC61000-4-2 protection
TRS3221E	TI/BB	2010+	SSOP16	3V to 5.5V single-channel RS-232 line driver/receiver with +/-15kV IEC ESD protection
TRSF3221E	TI/BB	0752+	SSOP-16	3V compliant IEC to 5.5V single-channel RS-232 with +/- 15kV ESD protection for 1Mbit/s line driver/receiver
TPIC43T01	TI/BB	10+	TSSOP38	Three-phase brushless motor RPM controller
TPS54972pwp	TI/BB	10+	HTSSOP28	9A Active Bus Termination/DDR Memory DC/DC Converter
sn74AHCT125pwr	TI/BB	10+	TSSOP-14	Quad bus buffer gate with three-state output
MSP430F2122IPWR	TI/BB	10+	TSSOP28	16-bit ultra-low-power microcontroller with 4kB flash, 512B RAM, 10-bit ADC, and USCI
TPS5410DRG4	TI/BB	10+	SOP-8	2A wide input range step-down Swift(TM) converter
BQ24035RHLRG4	TI/BB	1014+	QFN-20	Charger with dynamic power path management, 6V output cut-off, and 4.2V battery regulation
BQ24400PWRG4	TI/BB	2009	TSSOP-8	Programmable NiCd/NiMH fast charge management device
BQ24702PWRG4	TI/BB	10+	TSSOP-24	Multi-compound battery charge controller and system power selector
BQ29400PWRG4	TI/BB	08+	TSSOP-8	Level 2 overvoltage protection for 2, 3 or 4 Li-Ion and Li-Polymer batteries (Level 2 protection)
BQ29401PWR	TI/BB	09+	TSSOP8	Voltage protection for 2, 3 or 4 lithium batteries (Level 2 protection)
BQ24105RHLRG4	TI/BB	10+	QFN-20	bqSWITCHER(TM) synchronous switch-mode Li-ion charger with 2A FET in QFN package, 1-cell to 3-cell standalone versions
BQ26150DCKRG4	TI/BB	TI/BB	SOT23-5	Battery pack safety certified IC for portable applications (bqSECURE)
BQ29411PWRG4	TI/BB	11+	TSSOP-8	Secondary Overvoltage Protection for 2-4 Series Li-Ion/Li-Polymer Batteries (4.40V)
BQ24081DRCTG4	TI/BB	08+	QFN10	Single-cell Li-Ion charger with 1A FET, timer enabler, and temperature sensing
BQ24031RHLRG4	TI/BB	2010+	QFN20	Single-Chip Charge and System Power-Path Management IC (bqTINY-III)