LT1016CS8

• Product Introduction

LT1016CS8 Ultra-fast and accurate 10ns comparator

peculiarity

Absolute maximum rating

• 正电源电压 (注 5) …… 7V
• 负电源电压 …… -7V
• 差分输入电压 (注 7) …… ±5V
• +IN、-IN 和 LATCH ENABLE 电流 (注 7) …… ±10mA
• 输出电流 (连续) (注 7) …… ±20mA
• 工作温度范围 …… -55℃ 至 125℃
• 贮存温度范围 …… -65℃ 至 150℃
• 引脚温度 (焊接时间 10 秒) …… 300℃

description

The RH1016 is an UltraFastTM 10ns comparator that connects directly to a TTL/CMOS logic circuit and operates from a ±5V or single 5V supply. Strict offset voltage specifications and high gain allow the RH1016 to be used in precision applications. The matched complementary output further expands the versatility of this comparator. A unique output stage provides active drive in both positive and negative directions and is designed to maximize the speed of TTL/CMOS logic circuits or passive loads without the high current spikes commonly found in traditional output stages. This allows the RH1016 to remain stable when the output is in the active region, greatly reducing the output "impulse interference" problem when the input signal is moving slowly or at low levels. The RH1016 has a LATCH pin that will retain input data on the output when kept high. The quiescent negative supply current is only 3mA. This enables the use of a simple resistive voltage divider to drive the negative power pin from virtually any supply voltage. Device performance is not affected by negative supply voltage variations. Wafer batches are processed using Linear Technology's Class S process-to-yield circuitry for use in rigorous military applications.