- Accurate sensory dead 2 remote IC or diode junction and temperature temperature of the place
- 0.125 °C, temperature resolution of LSB
- Enables 0.03125°C LSB digital filtering remote temperature resolution
- 127.875°C/-128°C and 0°C/255°C remote range
- Programmable digital filters and analog front-end filters
- Remote diode fault detection, model selection and offset correction
- Mask and status register support
- 3 programmable^ TCRIT outputs programmable to share hysteresis
- Programmable transfer rate and shutdown mode, one-time changeover control
-
SMBus 2.0 compatible interface, supported Timeout
- Three levels of address pins
- 14-pin LLP package
illustrate
LM95213 is an 11-bit 2-wire System Management Bus (SMBus) interface digital temperature sensor that monitors the temperature of two remote diodes as well as their own temperature. LM95213 can be used to monitor temperatures up to two external devices such as microprocessors, graphics processors, or connected into the 2N3904 series of diodes very accurately.
LM95213 reported temperatures in the 127.875°C/-128°C temperature range and 0°C/255°C in two different formats. LM95213^TCRIT1,^TCRIT2^TCRIT3 outputs trigger any east-window event channel when it exceeds its corresponding programmable limit and can be used to shut down the system, steer the system fan, or as an interrupt function for the microcontroller. The status of the ^TCRIT1,^ TCRIT2 and ^ TCRIT3 pins can read state registers. Shielded registers can be used to further control the ^ TCRIT output.
LM95213 remote temperature channel programmable digital filter to minimize unnecessary^TCRIT events when temperature spikes are encountered.
For optimal flexibility and accuracy, include a 2N3904 diode with a 2N3904 diode for each LM95213 channel offset correction register. A 3-level address pin allows up to 3 LM95213s to be connected to the same SMBus master. LM95213 include power-saving features such as programmable slew rate, shutdown mode, and shutdown of unused channels.
Key specifications:
■ Local temperature accuracy
|
± 2.0 ° C (max)
|
■ Remote diode temperature accuracy
|
± 1.1 °C (max)
|
■ Supply voltage
|
3.0 V to 3.6 V
|
■ Average supply current (1Hz conversion rate)
|
0.57 mA (typical)
|
apply
-
Processor/computer system thermal management
(e.g. laptops, desktops, workstations, servers)
- Electronic test equipment
- Office electronics
|