Check out mode
Item model |
Thru-beam type |
| F3W-D052A （P）*1 |
F3W-D052B （P）*1 |
F3W-D052U（P）*1 |
| Detection distance |
3m (LONG mode: 1~3m, SHORT mode: 0.05~1m switch switching) ※SHORT mode |
| Optical axis spacing |
25mm |
| Number of optical axes |
5 optical axis |
| Detection amplitude |
100mm |
| Standard detection objects |
Opaque objects above φ35mm |
| Light source (luminous wavelength) |
Infrared LED (860nm) |
| Supply voltage |
DC12~24V±10% pulsation (p-p) less than 10%. |
DC24V±10% pulsation (p-p) or less (supply voltage that can also be supplied according to independent line system can also be used on other power supplies) |
| Consume electricity |
Optical projector: 0.6W or less, light receiver: 0.7W or less |
Projector/receiver: 0.6W or less each |
| Control the output |
Load supply voltage DC30V, load current 100mA or less (residual voltage 1V or less) NPN collector open circuit output ON/ON switching type when light is in / shading when light is entered |
Transmission input (input address is set by SW3 indication input address setting switch) |
| Select Indicate Input |
Open circuit by contact or contactless collector Lamp input voltage: 0~2V Lamp-out input voltage: open circuit (leakage current below 0.1mA) |
Transmission input (input address is set by SW2 indication input address setting switch) |
| Protection circuit |
Power supply reverse connection protection, output short circuit protection, anti-mutual interference function (same wave number switching mode) |
| Response time |
Working/resetting: less than 10ms each |
Operating/resetting: 39ms (64bit) each / 66ms (128bit) each / 120ms (256bit) or less each*2 |
| Represents a lamp |
Light receiver |
Working indicator lamp (orange), steady light indicator lamp (green), selection indicator lamp (orange) 6 lamp, direct junction type transmission indicator lamp for independent line (orange)*3 |
| Light projector |
Power supply indicates lamp (green), different frequency indicator lamp (green), selection lamp (orange) 6 lamps, direct junction transmission lamp for independent lines (orange)*3 |
| Ambient temperature |
Working time: -10~+55°C, storage: -25~+70°C (no freezing, condensation) |
| Ambient humidity |
Working and storing: 35~85%RH (non-condensing) |
| Insulation resistance |
20MΩ or more (DC500V megohmmeter) |
| Withstand voltage |
AC1,000V 50/60Hz 1min |
| Vibration (durable) |
10~50Hz dual amplitude 1.5mm X, Y, Z 2h in all directions |
| Impact (durable) |
500m/s2 3 times in all directions of X, Y, Z |
| Protection Construct |
IEC size IP62 (with operating cover closed) |
| Continuation method |
Conductor exit type (standard wire length 5m) * 4 |
Connector repeater type (standard wire length 2m) * 4 (M12, 5-pole socket) |
Conductor exit type (marked wire length 2m) |
| Quality (bale status) |
Approx. 360g |
Approx. 230g |
Approx. 220g |
| Material |
Housing/representation window |
ABS |
| Lens Department |
propylene |
| Operate the lever |
Nylon (PA6) |
| accessory |
Operating instructions |