ISL705BEH

• Product introduction

Key features

Electrical shielding patch 5962 - 11213
QML qualifies as required per MIL-PRF-38535
Radiation resistant
High dose rate: 100krad(SI)
Low dose rate: 100krad(SI)
SEL/Cyberlet TH: 86MeV * 2 cm/mg
Precision supply voltage monitor
ISL705AEH/BEH/CEH at the 4.65V threshold
ISL706AEH/BEH/CEH at the 3.08V threshold
(typical), 200ms reset pulse width
Active high, active open-drain options
The independent watchdog timer has a timeout of 1.6s (typical).
High accuracy threshold detector
ISL705AEH/BEH/CEH at the 1.25V threshold
The 0.6V threshold is at the ISL706AEH/BEH/CEH
Debounced TTL/CMOS compatible with manual reset inputs
The reset output is valid at VD = 1.2V
description

The radiation-tolerant 5.0V/3.3V supervision circuitry of these devices reduces the complexity required to monitor supply voltages in microprocessor systems. These devices greatly improve accuracy and reliability relative to discrete solutions. Each IC provides four key functions.

1。 A reset output during power-up, power-down, and undervoltage conditions.

2。 An independent watchdog output goes low if the watchdog input has not switched within 1.6 seconds.

3。 A high-precision threshold detector other than V DD for monitoring the power supply.

4。 An active-low manual reset input.

The equipment for the specification of the Rad Hard QML is controlled by the Defense Logistics Agency Land and Maritime (DLA). When placing an order, you must use the SMD numbers listed in the order information sheet on page 3.

Detailed electrical specifications for ISL705AEH ISL705BEH, ISL705CEH, ISL706AEH, ISL706BEH and ISL706CEH are loaded on SMD 5962-11213. Hotlinks are also available for download on our website.

apply

μ - Supervision of processors, μ controllers, FPGAs and DSPs
Critical power monitoring
A reliable alternative to discrete solutions