AD7466BRTZ-R2

• Product introduction

AD7466BRTZ-R2 1.6 V micropower 12-bit ADCs The AD7466/AD7467/AD7468 are 12/10/8-bit high speed, low power successive approximation modulos, respectivelyconverter(ADC) operating from a single 1.6V to 3.6V supply with low power consumption and throughput up to 200 kSPS. The device contains a low noise, wide bandwidth track-and-hold amplifier that can handle input frequencies above 3 MHz.

The conversion process and the data acquisition process pass.CSand the serial clock to create the conditions for the device to interface with a microprocessor or DSP. The input signal is in.CSis sampled on the falling edge, and the transformation starts here at the same time. There is no pipeline delay.

The reference voltage is from V_DD This provides the ADC with the widest dynamic input range and, therefore, its analog input range is 0 to V_DD 。 The slew rate depends on the SCLK.

Product Focus

1. Rated supply voltage: 1.6 V to 3.6 V
2. 12-, 10- and 8-bit ADCs available in SOT-23 and MSOP package modes
3. High throughput, low power consumption, maximum power consumption of 0.9 mW in normal operation at 100 kSPS at 3 V
4. Flexible power/serial clock speed management. The slew rate depends on the serial clock, and the conversion time can be shortened by increasing the serial clock rate. It automatically enters power-down mode after conversion, reducing the average power dissipation in power-down mode of 0.1 μA maximum, typically 8 nA in power-down mode
5. The reference voltage is derived from the power supply
6. No pipeline delay
7. The device features a standard successive approximation ADC that passes.CSThe input provides precise control over the conversion

apply
 

• Battery-powered system
• Medical instruments
• Remote data collection
• Isolated data acquisition

Professional sensors