A6261KLPTR-T

• Product Introduction

The A6261 is a linear, programmable current regulator that delivers 100 mA each to 4 outputs to drive an array of high-brightness LEDs. The regulated LED current (accurate to 5%) for each output is set by a single reference resistor. No ballast resistor is used, and the current match per string is better than 10%. The use of constant current drive LEDs ensures safe operation and provides the maximum possible illumination output.

Provide output control by enabling input commands to provide direct control for PWM applications. The output can be paralleled or idle as needed.

Short circuit detection is provided to protect the LEDs and the A6261 when any LED output pin is shorted to ground. An open LED in any string can disable all outputs, but the function can be overridden. The fault flag shows a short-circuit LED output pin or an open-circuit LED.

The product includes a temperature monitor to reduce the LED drive current if the chip temperature exceeds the thermal threshold.

The devices are available in 10-pin MSOP (LY) and 16-pin TSSOP (LP) packages, both of which feature exposed heat sinks for enhanced heat dissipation. The packages are lead-free and the pin frames are 100% matte tin plated.

• LED 驱动器总电流高达 400 mA
• 电流由 4 个串平均分配，每个 100 mA
• 6 至 50 V 电源电压
• 低压差
• LED 输出短路接地和过热保护
• 禁用开路 LED 侦测选项
• 启用 PWM 控制输入
• PWM 期间电流限摆率
• 通过参考电阻设置电流
• 汽车 K 温度范围（–40°C 至 150°C）：请联系工厂了解供货情况。