A6262KLPTR-T

• Product Introduction

The A6262 is a linear, programmable current regulator that delivers 100 mA each to the 4 outputs to drive a high-brightness LED array. The regulated LED current (accurate to 5%) for each output is set by a single reference resistor. No ballast resistor is used, and the current match per string is better than 10%. The use of constant current drive LEDs ensures safe operation and provides the maximum possible illumination output.

Provides output control by enabling input commands, providing direct control for PWM applications; And the on/off toggle operation is performed through the debounce switch input.

For automotive applications, peak performance is achieved when 4 strings are driven with 1 to 3 LEDs in each string, each with a total current of up to 100 mA. The output can be paralleled or idle as needed.

Short circuit detection is provided to protect the LEDs and the A6262 when any LED output pin is shorted to ground. After eliminating the short circuit, the output will automatically restore the regulated current.

The product includes a temperature monitor to reduce the LED drive current if the chip temperature exceeds an adjustable thermal threshold.

The devices are available in 10-pin MSOP (LY) and 16-pin TSSOP (LP) packages, both of which feature exposed heat sinks for enhanced heat dissipation. The packages are lead-free and the pin frames are 100% matte tin plated.

• LED 驱动器总电流高达 400 mA
• 电流由 4 个串平均分配，每个 100 mA  
• 6 至 50 V 电源电压
• 低压差
• LED 输出短路接地和过热保护
• 开/关拨动开关输入
• 启用 PWM 控制输入
• PWM 期间电流限摆率
• 通过参考电阻设置电流
• 汽车 K 温度范围（–40°C 至 150°C）：请联系工厂了解供货情况。