A8513KLYTR-3-T

• Product Introduction

The A8513 is a single-output white LED (WLED) driver for LCD backlighting. It integrates a current-mode boost converter with an internal power switch and a current draw-in device. The A8513 can be operated from a single 4.5 to 40 volt power supply to meet start/shutdown, cold start, and load dump requirements. The 2 MHz boost converter switching frequency allows the A8513 to operate above the AM radio band.

If desired, fault markers can be used as part of the circuit to drive the input power to the external P-FET disconnect system in the event of a fault. The A8513 offers a variety of protections, including output short-circuit and overvoltage, open-circuit or short-circuit diodes, open-circuit or short-circuit LED pins, short-circuit boost switches or inductors, short-circuit ISET resistors, and IC over-temperature protection. The two-stage wave-by-wave current limiting feature provides soft start and protection against high current overloads in the internal current switch.

The A8513 is available in a 10-pin MSOP package (suffix LY) and a 16-pin TSSOP package (suffix LP). Both packages have exposed pads for improved heat dissipation and are lead-free, with 100% matte tin plating on the pin frame.

apply

LCD Backlight:

• 汽车娱乐资讯
• 汽车蓄电池组
• 汽车中控台
• 工业 LCD 显示
• 便携式 DVD 播放器
• 平板扫描仪
• LED 照明
• • 4.5 至 40 伏特宽输入电压范围，可满足启动/关闭、冷车启动和负载突降要求
  • 升压转换器开关频率高达 2 MHz，可在 AM 波段以上运行
  • 出色的输入电压瞬态响应
  • 用于冗余保护的内部次级过电压保护
  • LED 灌电流和升压转换器与 60 伏特 DMOS FET 完全整合
  • 最大 LED 电流达 150 mA
  • 可驱动 14 个串联 LED
  • 为 PWM 光暗和启用功能提供单个 EN/PWM 引脚接口
  • 故障标记引脚可警告控制器大量可能的故障状态
  • 保护功能：
    • 短路输出保护
    • 开路或短路 LED 引脚保护
    • 输出欠压及过压
    • 输入欠压
    • 短路升压开关或电感器保护
    • 短路 ISET 电阻器
    • 开路升压肖特基保护
    • 过温