• Product Introduction

ACS716KLATR-12CB-NL-T 120 kHz bandwidth, high-voltage insulated current sensor IC with integrated overcurrent detection

The Allegro® ACS710 current sensor IC provides an affordable and accurate solution for current sensing applications in industrial, commercial, and communication systems. The device comes in a small wall-mounted package for ease of user use.

The ACS710 device has an accurate linear Hall sensor integrated circuit with a copper current path close to the surface of the wafer. The applied current flows through the copper current path, while the analog output voltage of the Hall sensor IC linearly tracks the magnetic field generated by the applied current. The accuracy of the ACS710 is maximized thanks to this patented packaging device, as the Hall components are positioned very close to the current to be measured.

Allegro's exclusive integrated screen technology provides high immunity to current conductor dV/dt signals and stray electric fields, ensuring low output voltage ripple and low bias drift in high-end, high-voltage applications.

The overcurrent voltage input (VOC pin) allows the user to set an overcurrent fault standard for this device. When the current flowing through the copper current path (between IP+ and IP– pins) exceeds this standard, the disconnected drain overcurrent fault pin goes into a logically low state. The write-only program of the ACS710's internal linear Hall sensor IC enables exceptionally accurate both analog and digital output signals.

The typical copper in-path resistance for current sensing is 1 mΩ with very little power loss. Moreover, the current path is isolated from the input and output of the low-voltage sensor. This allows the ACS710 sensor series to be used in applications where electrical isolation is required without the use of photoisolators or other expensive insulation technologies.

apply

• 电动机控制与保护
• 负载管理与过流检测
• 功率变换与电池监控 /UPS 系统

• 通过专利放大器和滤波器设计工艺实现高带宽行业领先的噪音性能
• 体积小，适用于有空间限制的应用。
• 1 mΩ 初级导体电阻产生的功率损耗小
• 高绝缘电压适合在电网火线应用
• 可供用户调整的过流故障标准
• 过流故障信号通常反映
• 由于 dV/dt 的高瞬变电压，集成屏幕事实上能完全消除电流导体中的电容耦合。
• 滤波管脚电容器能提高低带宽应用中的分辨率。
• 3 至 5.5 V, 单电源工作
• 厂家设定的灵敏度和静态输出电压
• 稳定斩波带来十分稳定的静态输出电压
• 电源电压的成比例输出