AD7451ART-R2

• Product introduction

AD7451ART-R2 псевдодифференциальный вход, 1 MSPS, 12-разрядный АЦП в 8-выводном корпусе SOT-23

The AD7441/AD7451 are 10-bit and 12-bit, high speed, low power, single supply, successive approximation (SAR) modules, respectivelyconverter(ADC) with pseudo-differential analog inputs, operating from a single 2.7 V to 5.25 V supply, maximum throughput of 1 MSPS, and very low power consumption.

The AD7441/AD7451 contain a low noise, wide bandwidth, differential sample-and-hold (T/H) amplifier that can handle input frequencies up to 3.5 MHz. The external reference voltage is via V_REF Pin input from 100 mV to V_DD Range varies, depending on the power supply and application.

The conversion process and data acquisition are controlled by active-low CS and serial clocks, allowing the device to interface with a microprocessor or DSP. The input signal is sampled on the falling edge of the active-low CS, where the conversion is initiated at the same time. These devices feature a SAR architecture to ensure no pipeline delay.

• High throughput: 1 MSPS
• Rated voltage (V_DD ): 2.7 V to 5.25 V
• Low power consumption (at maximum throughput):
  4 mW maximum (1 MSPS, V_DD = 3 V）
  9.25 mW maximum (1 MSPS, V_DD = 5 V）
• Wide input bandwidth: 70 dB signal-to-a-a-ratio (100 kHz input frequency)

• Pseudo-differential analog input
• Flexible power/serial clock speed management
• No pipeline delay
• HIGH-SPEED SERIAL INTERFACE: SPI®-/QSPI™/MICROWIRE™-/DSP-compatible
• Power-down mode: 1 μA maximum
• 8-pin SOT-23 and MSOP packages

Temperature sensor