AD7452BRT-REEL7

• Product Introduction

AD7452BRT-REEL7 differential input, 555 kSPS, 12-bit ADC in an 8-pin SOT-23 package

The AD7452 is a 12-bit, low-power, successive approximation (SAR) analog-to-digital converter (ADC) that uses a fully differential analog input and operates from a single 3 V or 5 V supply with a maximum throughput of 555 kSPS.

The device has a built-in low-noise, wide-bandwidth, differential sample-hold (T/H) amplifier that can handle input frequencies above 1 MHz and a -3 dB bandwidth of 20 MHz typical. The external reference voltage is input via the VREF pin and can vary from 100 mV to 3.5 V, depending on the power supply and application. The voltage reference value determines the common mode voltage range of the device. With this true differential input structure and variable reference input, users can select various input ranges and bias points.

The conversion process and data acquisition are controlled by CS and serial clocks, creating the conditions for the device to interface with a microprocessor or DSP. The input signal is sampled at the falling edge of the CS, and the conversion is initiated here at the same time.

The device features a SAR architecture that ensures no pipeline latency.

The AD7452 features advanced design techniques that enable extremely low power consumption at high throughput.

• 额定电压(V_DD)：3 V和 5V
• 低功耗（最大吞吐量时）：
  - 最大7.25 mW（555 kSPS、5 V电源）
  - 最大3.3 mW（555 kSPS、3 V电源）
• 全差分模拟输入
• 宽输入带宽：
  - 70 dB信纳比（100 kHz输入频率）

• 灵活的功耗/串行时钟速度管理
• 无流水线延迟
• 高速串行接口： SPI®/QSPI™/MICROWIRE™/DSP 兼容
• 省电模式：最大1 µA
• 8引脚SOT-23封装

Temperature sensor