AD9680

• Product introduction

AD9680 Dual, 14-Bit, 1 GSPS Analog-to-Digital Converter (ADC)

The AD9680 is a dual, 14-bit, 1 GSPS analog-to-digital converter (ADC). The device includes an on-chip buffer and sample-and-hold circuitry designed for low power, small size, and ease of use. The device is designed for sampling wideband analog signals up to 2 GHz. The AD9680 is optimized for wide input bandwidth, high sample rate, excellent linearity, and low power consumption in a small package.

This dual ADC core uses a multistage, differential pipelined architecture with integrated output error correction logic. Each ADC has wide bandwidth inputs that support a variety of user-selectable input ranges. An integrated reference simplifies design.

Both the analog input and the clock signal are differential. Each ADC data output is internally connected to two digital downconverters (DDCs). Each DDC contains four cascaded signal processing stages: a 12-bit frequency converter (NCO) and four half-band decimation filters.

In addition to the DDC block, the AD9680 has additional features that simplify automatic gain control (AGC) of communication receivers. Using the ADC's fast sense output bits, a programmable threshold detector monitors the input signal power. If the input signal level exceeds a programmable threshold, the quick detect indicator goes high. The very low latency of this threshold indicator allows the user to quickly lower the system gain to avoid overrange at the ADC input.

The user can configure the subclass 1 JESD204B high-speed serial output as 1, 2, or 4 lanes, depending on the DDC configuration and the acceptable channel rate of the receiving logic. Multi-device synchronization support is provided through SYSREF ± and SYNCINB ± input pins.

Product features

1. The full-power, wide-bandwidth feature supports sampling of IF signals up to 2 GHz.
2. Buffered inputs with programmable input termination simplify filter design and deployment.
3. Four integrated wideband decimation filters and digitally controlled oscillator (NCO) modules support multiband receivers.
4. A flexible serial port interface (SPI) controls a variety of product features and functions to meet specific system requirements.
5. Programmable fast overrange detection.
6. 9mm x 9mm 64-pin LFCSP package

apply

• correspondence
• Diversity multiband, multimode digital receiver
  3G/4G、TD-SCDMA、W-CDMA、GSM、LTE
• Universal software defined radio
• Ultra-wideband satellite receiver
• Instrumentation
• radar
• Signals Intelligence (SIGINT)
• DOCSIS 3.0 CMTS upstream receive path
• HFC digital reverse path receiver

Shenzhen Xinwei Centennial Electronics Co., Ltd

Address: Shenzhen Futian District Huaqiang Road Huaqiang Plaza A Block 13H

Tel: 0755-83591082

Fax: 0755-83591083

Q Q：1051085817

//www.chip100.com/