APEK8603KES-01-MH

• Product Introduction

The A8603 is a fixed-frequency multi-output power supply for LCD bias. The device can be programmed or synchronized with an external clock signal to obtain a 350 kHz to 2.25 MHz switching frequency. This minimizes interference with the AM and FM bands.

Utilizing an I2C-compatible serial interface, the system microcontroller can configure the A8603 by writing to its internal registers. In the event of a failure, the system controller can also access the A8603 status registers.

The A8603 integrates a boost stage followed by two linear regulators and two charge pump regulators. Each output voltage can be programmed independently via a serial interface. During power-up and shutdown, the output can be turned on and off in a pre-programmed sequence (with adjustable delay). This allows for the sequencing requirements of specific LCD panels.

All outputs are short-circuit protected. The boost switch has overcurrent and overvoltage protection.

The A8603 is available in a 24-pin 4-× 4 mm QFN and 24-pin TSSOP package, both of which come with exposed thermal pads to operate at higher ambient temperatures. The packaging is lead-free and 100% matte tin plated.

apply

• GPS
• 资讯娱乐
• 中型 LCD
• • 符合汽车 AEC-Q100 标准
  • 输入电压 3V 至 10V
  • 四个单独输出电源
  • 独立控制每个输出电压
  • 提高开关频率：350 kHz 至 2.25 MHz
  • 提供外部同步功能。
  • 频率抖动以减少 EMI
  • 关断电流小于 10 µA
  • 保护功能：过电流、过电压、
  • 短路和热过载保护
  • 通过 I²C 实现完全可编程输出
    • 稳压器电压
    • 启动/关闭顺序
    • 故障重试计数器