| Detection method |
Thru-beam type
|
Regressive reflex
(M.S.R. with reflector)
|
Diffusion reflective type |
type
Item number |
NPN output |
E3Z-T61(K)
E3Z-T66
|
E3Z-T62
E3Z-T67
|
E3Z-T61A
E3Z-T66A |
E3Z-R61/R66 |
E3Z-R61K |
E3Z-D61(K)/D66 |
E3Z-D62(K)/D67 |
| PNP output |
E3Z-T81(K)
E3Z-T86
|
E3Z-T82
E3Z-T87
|
E3Z-T81A
E3Z-T86A |
E3Z-R81/R86 |
E3Z-R81K |
E3Z-D81(K)/D86 |
E3Z-D82(K)/D87 |
| Detection distance |
15m |
30m |
10m |
4m [100mm] * (when using E39-R1S) 3m [100mm] * (when using E39-R1) |
3m [150mm] * (when using E39-R1S) 2m [100mm] * (when using E39-R1) |
100mm
(White paper.)
100×100mm） |
1m
(White paper.)
300×300mm） |
| Beam diameter |
—— |
| Standard detection objects |
Opaque objects above φ12mm |
Opaque objects above φ75mm |
—— |
| Minimum detected object |
—— |
| Should be poor |
—— |
The detection distance is less than 20%. |
| Point to the angle |
Projection and light receiver: 3~15° each |
2～10° |
—— |
Light source (luminous wavelength)
|
Infrared photodiode
（870nm）
|
Red LED (660nm)
|
Red light-emitting diode
（660nm）
|
Infrared light diode
（860nm） |
| Supply voltage |
DC12~24V±10% fluctuation (p-p) 10% or less |
Consumes current
|
Light projector: 15mA
Receiver: 20mA |
Below 30mA |
| Control the output |
Load supply voltage DC26.4V or less, load power supply current 100mA or less Residual voltage Load current 10mA less than 1V Load current 10~100mA: 2V or less
Open collector output (NPN/PNP output varies by model)
ON switch type when light enters / ON when shading |
| Protection circuits |
Power supply reverse connection protection, output short circuit protection |
Power protection reverse connection protection, output short circuit protection, mutual interference prevention function, output reverse connection protection |
| Response time |
Action, reset: less than 1ms each |
| Sensitivity adjustment |
One-way knob |
| illuminating |
Illuminance of the light-receiving surface, incandescent lamp: 3,000lx or less, sunlight: 10,000lx or less |
| Ambient temperature |
When operating: -25~+55°C, when storing: -40~+70°C (no freezing, condensation) |
| Ambient humidity |
When operating: 35~85%RH, when storing: 35~95%RH (no icing) |
| Insulation resistance |
20MΩ or more (DC500V megohmmeter) |
| Withstand voltage |
AC1,000V 50/60Hz 1min |
| Vibration resistance (durable) |
10~55Hz dual amplitude 1.5mm X, Y, Z 2h in all directions |
| Impact resistant (durable) |
500m/s2 3 times in all directions of X, Y, Z |
| Protection Construct |
IEC specification IP67 (oilproof type: IEC specification IP67 (except JEM specification IP67f conductor and connector)) |
| Connection method |
Lead wire (standard length 2m/500mm) / M8 connector type / M8 connector trunk type (oilproof type) |
| Light |
Action display light (orange) Steady display light (green) [but the light projector is a power display light (orange)] |
quality
(Bundle Status) |
The wire leads out
Type 2m |
Approx. 120g |
Approx. 65g |
| Connector type |
Approx. 30g |
Approx. 20g |
M8 connector
Repeated
|
Approx. 50g |
Approx. 30g |
| Material |
enclosure |
Polybutylene terephthalate |
| Lens Department |
Polyurethane rubber |
Methapropylene resin |
Polyurethane rubber |
| annex |
Instruction manual, Note: Return reflector, mounting metal accessories sold separately |