| Item model |
EE-SPW311 EE-SPW411 |
| Detection distance |
1m |
| Standard detection objects |
¢Opaque objects of 5mm or more |
| Point to the angle |
5-200
|
| Light source (maximum luminous wavelength) |
GaAs infrared light-emitting diode (pulse light) (940nm) |
| Display light*1 |
Light on when entering the light (red) |
| Supply voltage |
DC5V-5%-24V± 10% fluctuation (p-p) less than 5%. |
| Consumes current |
Cast. Optical receiver: less than 20mA each |
| Control the output |
NPN crystal collector open circuit output load supply voltage DC5V-24V
Load current 100mA or less
Residual voltage 0.8V or less (at 100mA load current)
Residual voltage 0.4V or less (at 10mA load current) |
| Response frequency*2 |
100Hz or more |
| Use ambient illumination |
Illuminance of the light-receiving surface Incandescent lamp: 1,000lx or lessSunlight: 3,000lx or less |
| Use ambient temperature |
When acting: -10-+550C When saving: -25—+650C |
| Use ambient humidity |
When operating: 5-85%RH When storing: 5-95%RH |
| Vibration (durable) |
200—2,000Hz (maximum acceleration 100m/s2)
The amplitude up and down is 1.5mmX Y Z 2h (4min cycle) in each direction |
| Impact (durable) |
500m/s2X Y Z 3 times in all directions |
| Protection Construct |
IEC specification IP60 |
| Connection method |
Connector type (do not aggressive soldering) |
| quality |
Approx. 8.8g |
| Material |
enclosure |
Polybendimethylene glycol (PBT) |
| lens |
polycarbonate |
| accessory |
EE-1006L/D also wire connector, instruction manual |