| Detection method
Project Model |
Opposite type |
| F3W-D052A （P）* 1 |
F3W-D052B （P）* 1 |
F3W-D052U（P）* 1 |
| Detection distance |
3m (LONG mode: 1~3m, SHORT mode: 0.05~1m switch switch) ※ SHORT mode |
| Optical axis spacing |
25mm |
| Optical axis number |
5. Optical switch |
| Detection amplitude |
100mm |
| Standard detection objects |
Opaque objects with diameters above φ35mm |
| Light source (luminous wavelength) |
Infrared LED (860nm) |
| Supply voltage |
DC12~24V±10% pulsation (p-p) below 10%. |
DC24V ± 10% pulsation (p-p) or less (power supply voltage can also be used on other power supplies according to the independent circuit system) |
| Electricity consumption |
Emitter: below 0.6W, receiver: below 0.7W |
Projector/receiver: each less than 0.6W |
| Control output |
Load power supply voltage DC30V, load current below 100mA (residual voltage below 1V), NPN collector open-circuit output, ON/ON switch when light is in, switchable when blocking light |
Input transmission (input address set by SW3 to indicate input address setting switch) |
| Select Instruction Input |
Open circuit via contactless or contactless collector Lighting input voltage: 0~2V Off input voltage: Open circuit (leakage current below 0.1mA) |
Input transmission (input address set by SW2 to indicate input address setting switch) |
| Protection circuit |
Power reverse connection protection, output short-circuit protection, and mutual interference prevention functions (same wavenumber switching method) |
| Answer time |
Operation/Reset: each less than 10ms |
Operation/Reset: Each 39ms (64bit) / Each 66ms (128bit) / Each below 120ms (256bit)*2 |
| Indicator light |
Receiver |
Operation indicator light (orange), stable light input indicator light (green), selection indicator light (orange) 6 lights, and 3 orange transmission indicator lights for independent line direct connection |
| floodlight |
Power indicator light (green), different frequency indicator lights (green), selectable indicator lights (orange), 6 lights, and 3 orange transmission indicator lights for independent line direct connection |
| ambient temperature |
During operation: -10~+55°C; When storing: -25~+70°C (no freezing or condensation) |
| ambient humidity |
During operation and storage: 35~85% RH (non-condensing) |
| Insulation resistance |
20MΩ or more (DC500V megaohmmeter) |
| Withstand voltage |
AC1,000V 50/60Hz 1min |
| Vibration (durable) |
10~50Hz Dual amplitude 1.5mm X, Y, Z directions for 2 hours |
| Impact (Durable) |
500m/s2 3 times in each direction of X, Y and Z |
| Protect the structure |
IEC specification: IP62 (when operating cover is closed) |
| Connection method |
Conductor outlet type (standard conductor length 5m) * 4 |
Connector relay type (standard wire length 2m) * 4 (M12, 5-pole socket) |
Wire Lead Type (Marked Wire Length 2m) |
| Quality (Bundle Status) |
About 360g |
About 230g |
About 220g |
| Material |
Shell/display window |
ABS |
| Lens section |
Propylene |
| Operate the lever |
Nylon (PA6) |
| accessory |
Operation manual |