-
DQ Power & Power supply : VDD & VDDQ = 1.5V +/- 0.075V
DQ power supply and power supply: VDD and VDDQ 1.5V + / - 0.075V
-
DQ Ground supply : VSSQ = Ground
DQ ground power: VSSQ = ground
-
Fully differential clock inputs (CK, /CK) operation
Fully differential clock input (CK/CK) operation
-
Differential Data Strobe (DQS, /DQS)
Differential Data Gating (DQS/DQS)
-
On chip DLL align DQ, DQS and /DQS transition with CK transition
The on-chip DLL aligns the transitions of DQ, DQS, and /DQS with the CK transition
-
DM masks write data-in at the both rising and falling edges of the data strobe
Mark masks write data, on the rising and falling edges of the data gating pulsesedge
-
All addresses and control inputs except data, data strobes and data masks latched on the rising edges of the clock
All addresses and the rising edge of the control input clock latches data, except data gating and data masks
-
Programmable CAS latency 6, 7, 8, 9, 10, 11, 12 and 13 supported
Programmable CAS delays 6, 7, 8, 9, 10, 11, 12 and 13In the tank
-
Programmable additive latency 0, CL-1, and CL-2 supported
Supports programmable additional delays 0, CL-1 and CL-2
-
Programmable CAS Write latency (CWL) = 5, 6, 7, 8,9 and 10
Programmable CAS Write Delay (CWL) = 5, 6, 7, 8, 9 and 10
-
Programmable burst length 4/8 with both nibblesequential and interleave mode
Nibblesequential and interleaved mode programmable burst length of 4/8
-
Programmable PASR(Partial Array Self-Refresh) for Digital consumer Applications
Programmable PASR (Partial Array Self-Refresh) for digital consumer applications）
-
Programmable BL=4 supported (tCCD=2CLK) for Digi-tal consumer Applications
Programmable BL = 4 support (TCCD = 2CLK) for digital consumer applications
-
Programmable ZQ calibration supported
Supports programmable ZQ calibration
-
BL switch on the fly
Fly on the "Basic Law" switch
-
8banks
8banks
-
8K refresh cycles/64ms
8K refresh cycles/64ms
-
JEDEC standard 96ball FBGA(x16)
JEDEC Standard 96ball FBGA (X16)
-
Driver strength selected by EMRS
EMRS selected driverstrength
-
Dynamic On Die Termination supported
Dynamic mode support is terminated
-
Asynchronous RESET pin supported
Supports asynchronous reset pins
-
Auto Self Refresh supported
Automatic self-refresh support
-
Write Levelization supported
Write levelization support
-
On Die Thermal Sensor supported
Thermal sensor support in mold
-
8 bit pre-fetch
8-bit prefetch
-
This product in compliance with the RoHS directive.
This product complies with the RoHS directive.