home page>Product Center> Current parallel monitor
INA213
Product images are for illustrative purposes only
Product details are welcome upon request

INA213

  • Category:Current parallel monitor
  • Product Name:Voltage output, high/low-side measurement, bidirectional zero-drift series current parallel monitors
  • Manufacturers:TI
  • Production Batch Number:10+
  • Encapsulation:10UQFN, 6SC70
  • Stock Status:There is stock
  • Stock Quantity:3000
  • Minimum order quantity: 1
  • Details:Click here to find the INA213 pdf
  • Click Request a quote
Contact usOnline customer service1 Online customer service2 Click Send email
  • Product introduction

The INA210, INA211, INA212, INA213, INA214 are voltage and output current shunt monitors that can sense the opposite side of the common-mode voltage shunt droplets from -0.3V to 26V, independent of the supply voltage. Five fixed incomes are available: 50V Audio/Video, 100V Audio/Video, 200V/V, 500V/V, or 1000V/Five The zero-drift architecture compensates for low currents by shunting up to 10mV of full-scale detection low-limit dips.

These devices operate from a single +2.7 V to +26 V supply and draw a maximum supply current of 100 μA. All versions are available in an extended operating temperature range (-40°C to +125°C) and in an SC70 package. The INA210, INA213, and INA214 are also available in a thin QFN package.

characteristic
  • Wide common-mode range: -0.3V to 26V
  • Offset Voltage: ±35μV (INA210 Max) (10mV Full-Scale Shunt Droplet Enabled)
  • precision
    • ± 1% gain error (maximum over temperature)
    • Offset drift of 0.5μV/°C (max.)
    • Gain drift at 10ppm/°C (max.)
  • Selected gain:
    • INA210: 200V audio/video
    • INA211: Audio/Video at 500V
    • INA212: 1000 volts/video
    • INA213: 50V audio/video
    • INA214: 100V audio/video
  • Quiescent Current: 100μA Max
  • SC70 package: all models
  • Thin QFN packages: INA210, INA213, INA214
  • apply
    • laptop
    • cell phone
    • Telecommunications equipment
    • power management
parameter
        INA213  
Gain (V/V).       50  
Common Mode Input Range (min) (5)       -0.3  
Maximum input offset (+/-)()(UV)       100  
Maximum input offset drift (+/-)((UV/Celsius)       0.5  
CMRR (minimum) (decibels)       100  
Small signal bandwidth (typical) (MHz)       0.014  
Quiescent current (+/-)(typical) (mA)       0.065  
and (min) (v)       2.7  
and (maximum) (v)       26  
Operating temperature range(°C)       -40 to 125  
Pins/Packets       10UQFN,6SC70  

andINA213Related ICs are:


Model Manufacturers lot number encapsulation illustrate
INA216A2 TI 10+ 4DSBGA A small, low-power current-sense amplifier for high-side sensing
INA216A1 TI 10+ 4DSBGA A small, low-power current-sense amplifier for high-side sensing
INA214-Q1 TI 10+ 6SC70 Automotive voltage output, high/low-side measurement, bidirectional zero-drift series
INA214 TI 10+ 10UQFN, 6SC70 Voltage output, high/low-side measurement, bidirectional zero-drift series current parallel monitors
INA213A-Q1 TI 10+ 6SC70 Automotive voltage output, high/low-side measurement, bidirectional zero-drift series current parallel monitors
TPS54426 TI 10+ 14HTSSOP 4.5V to 18V input, 4A synchronous step-down SWIFT™ converter with light load power savings
TPS54425 TI 10+ TSSOP14 4.5V to 18V input, 4A synchronous step-down SWIFT™ converter with D-CAP2™ mode
TPS54418 TI 10+ QFN-16 A full-featured 6-volt, 4-amp, current-mode converter that synchronizes two integrated MOSFETs in one step
TPS54380-Q1 TI 10+ TSSOP20 3V to 6V Input 3A Synchronous Buck Converter for Sequencing
TPS54380 TI 10+ TSSOP20 3V to 6V Input 3A Synchronous Buck Converter for Sequencing

Popular searches


Model Manufacturers lot number encapsulation illustrate
AS7C4096A-15JIN Alliance Memory Inc 23+ SOJ-36 AS7C4096A Series 4-Mbit (512 K x 8) 5 V 15 ns CMOS Static RAM - SOJ-36
US-625AXTLQE ASAHI KEIKI 2023+ weld Temperature sensor
V23154D735B110 TE 2023+ Relays Low Signal Relay - PCB V23154D 735B110
V23154D735F104 TE 23+ Relays Signal Relays, 250 VDC Contact Voltage, 250 VAC Contact Voltage, 806 mW Coil Power (DC), Printed Circuit Board, PCB-THT, Axicom Cradle Relay N
AZ16-12ZIBI-1747-M20 SCHMERSAL 2023+ switch Safety gate switch
PW70d(2x10432Ω/83°) FSG 2023+ potentiometer PW70D(2*1043Ω 1%/83°)(1700Z04-257.106)
PW70d FSG 2023+ potentiometer PW70D(2*1043Ω 1%/83°)(1700Z04-257.106)
S34ML16G202BHI000 Flip Electronics 2051+ 63BGA 16 Gb, 3 V, 4-bit ECC, x8 I/O, SLC NAND Flash Memory for Embedded
FRCIR06RGG18-20S-F80-V0-M20-1.5F ITTVEAM 2023+ connector Connectors, Circular Connectors, Circular Plugs & Receptacles
CL1215-02P72ET-U2 Schaltbau 2023+ Contactors CL1215/02 P 72ET-U2 1, 2 and 3 pole AC and DC NO contactors for voltages up to 1,500 V
CL1115-02P72ET-U2 Schaltbau 2023+ Contactors 1, 2 and 3 pole AC and DC NO contactors for voltages up to 1,500 V
D-U204N-KLGQ Mors Smitt 2023+ Relays No magnetic arc blow-out
D-U204N-KLCQ Mors Smitt 2023+ Relays No magnetic arc blow-out
MIP30F00830-S1048 Amphenol Positronic 2023+ connector MIP series connectors
C163C/110EV-R1 Schaltebao 2023+ Contactors Contactors
F670-H4V-XUU LEACH 2023+ Relays F670-H4V-XUU+SHKE470-110-AD
F670-H4VP-XUXU LEACH 2023+ Relays F670-H4VP-XUXU+SFE670-1-1
AZ16-12ZI-B1-1747-M20 SCHMERSAL 2023+ switch Safety switches
RX2025GE1 Surio 2023+ connector Extract, Remove, and Insert Tools Contact extraction tool #16
5106.021.09.24 Surio 2023+ connector Extract, remove, and insert tools Extract tool with pop-up

TI brand product recommendation


Model Manufacturers lot number encapsulation illustrate
TPS54426 TI 10+ 14HTSSOP 4.5V to 18V input, 4A synchronous step-down SWIFT™ converter with light load power savings
TPS54425 TI 10+ TSSOP14 4.5V to 18V input, 4A synchronous step-down SWIFT™ converter with D-CAP2™ mode
TPS54418 TI 10+ QFN-16 A full-featured 6-volt, 4-amp, current-mode converter that synchronizes two integrated MOSFETs in one step
TPS54380-Q1 TI 10+ TSSOP20 3V to 6V Input 3A Synchronous Buck Converter for Sequencing
TPS54380 TI 10+ TSSOP20 3V to 6V Input 3A Synchronous Buck Converter for Sequencing
TPS54377 TI 09+ QFN24 The sucked 3V to 6V input, 3A synchronous buck converter is disabled during startup
TPS54373 TI 10+ TSSOP-20 The sucked 3V to 6V input, 3A synchronous buck converter is disabled during startup
TPS54372-Q1 TI 10+ 20HTSSOP Automotive 3A output tracking/terminal synchronous PWM transfer switch
TPS54372 TI 10+ HTSSOP-20 3A active bus termination/DDR memory DC/DC converter
TPS54362-Q1 TI 10+ HTSSOP16 Automotive 3A, 60V step-down DC/DC converter with low IQ, voltage monitoring, and reset
TPS54357 TI 10+ HTSSOP16 4.5V to 20V input, 5V output, 3A synchronous buck converter with low-side FET gate drive
TPS54356-EP TI 10+ HTSSOP16 4.5V to 20V input, 3.3V output, 3A synchronous buck converter with low-side FET gate drive
TPS54356 TI 10+ HTSSOP16 4.5V to 20V input, 3.3V output, 3A synchronous buck converter with low-side FET gate drive
TPS54355 TI 1049+ TSSOP16 4.5V to 20V input, 2.5V output, 3A synchronous buck converter with low-side FET gate drive
TPS54354-EP TI 10+ HTSSOP16 4.5V to 20V input, 1.8V output, 3A synchronous buck converter with low-side FET gate drive
TPS54354 TI 10+ HTSSOP16 4.5V to 20V input, 1.8V output, 3A synchronous buck converter with low-side FET gate drive
TPS54353 TI 10+ HTSSOP-16 4.5V to 20V input, 1.5V output, 3A synchronous buck converter with low-side FET gate drive
TPS54352 TI 10+ HTSSOP16 4.5V to 20V input, 1.2V output, 3A synchronous buck converter with low-side FET gate drive
TPS54350-EP TI 10+ HTSSOP16 4.5V to 20V input, 3A synchronous buck converter with low-side FET gate drive
TPS54350 TI 10+ HTSSOP16 4.5V to 20V input, 3A synchronous buck converter with low-side FET gate drive

Categorical search