ISL34341

• 24-bit RGB transport over single differential pair
• 6MHz to 40MHz pixel clock rates are pixel clock frequencies from 6MHz to 40MHz
• Bi-directional auxiliary data transport without extra bandwidth and over the same differential pair
• I 2 C Bus Mastering to the remote side of the link with a controller on either the serializer or deserializer I 2 C Bus Controller masters the remote side and the link, whether it is a serializer or deserializer
• 40MHz PCLK transports 40MHz PCLK transport
  • SVGA 800x600 @ 70fps, 16% blanking SVGA 800*600 @ 70fps, 16% blanking
  • WSVGA 1024x600 @ 60fps, 8% blanking WSVGA 1024x600 @ 60fps, 8% blanking
• Internal 100Ω termination on high-speed serial lines
• DC balanced with industry standard 8b/10b line code allows AC-coupling
  • Provides immunity against ground shifts
• Hot plugging with automatic resynchronization every line
• 16 programmable settings each for transmitter amplitude boost and pre-emphasis and receiver equalization allow for longer cable lengths and higher data rates 16 programmable settings for transmitter amplitude increase and pre-emphasis and receive equalization, each allowing for longer cable lengths and higher data rates
• Programmable power-down of the transmitter and the receiver
• Same device for serializer and deserializer simplifies inventory for the same device
• I 2C communication interface
• 8kV ESD rating for serial lines 8kV is for serial lines
• Pb-free (RoHS compliant) Lead-free (RoHS compliant)

The ISL34341 is a serializer/deserializer of LVCMOS parallel video data ISL34341. The video data presented to the serializer on the parallel LVCMOS bus is serialized into a high-speed differential signal. This differential signal is converted back to parallel video at the remote end by the deserializer. It also transports auxiliary data bi-directionally over the same link during the video vertical retrace interval.

I 2 C bus mastering allows the placement of external slave devices on the remote side of the link. The I2C bus master allows the remote connection to be placed as a slave to external devices. An I 2 C controller can be placed on either side of the link allowing bi-directional I 2 C communication through the link to the external devices on the other side , allowing bidirectional C communication, through the all-round I2. Both chips can be fully configured from a single controller or independently by local controllers.