Key features:
Electrical Shielding Patch 5962 - 11213
QML meets the requirements of MIL-PRF-38535
Radiation resistant
High Dose Rate: 100 krad (SI)
Low Dose Rate: 100 krad (SI)
SEL/Cyber Jean TH: 86MeV * 2 cm/mg
Precision power supply voltage monitor
ISL705AEH/BEH/CEH at the 4.65V threshold
ISL706AEH/BEH/CEH at the 3.08V threshold
(typical), 200ms reset pulse width
High active and low active drain open options
The independent watchdog timer is a timeout of 1.6s (typical).
High-precision threshold detector
ISL705AEH/BEH/CEH at the 1.25V threshold
The 0.6V threshold is at ISL706AEH/BEH/CEH
Debounced TTL/CMOS compatible with manual reset inputs
The reset output is effective at V DD = 1.2V
description
The radiation-tolerant 5.0V/3.3V supervisory circuitry of these devices reduces the complexity required to monitor supply voltages in microprocessor systems. These devices greatly improve accuracy and reliability compared to discrete solutions. Each IC provides four key functions.
1。 A reset output is in power-up, power-down, and undervoltage conditions.
2。 A separate watchdog output becomes low if the watchdog input has not been switched within 1.6 seconds.
3。 A high-precision threshold detector other than V DD for monitoring power supplies.
4。 A low-level effective manual reset input.
To regulate the equipment of the RAD Hard QML, it is controlled by the Defense Logistics Agency's Land and Maritime (DLA). When ordering, you must use the SMD figures listed in the ordering information sheet on page 3.
Detailed electrical specifications ISL705AEH ISL705BEH, ISL705CEH, ISL706AEH, ISL706BEH and ISL706CEH are contained in patch 5962-11213. Download on our website, hotlinks are also available.
apply
μ - Supervision of processors, μ controllers, FPGAs, and DSPs
Critical power monitoring
A reliable alternative to discrete solutions