ISL96017

• Integrated Digitally Controlled PotentiometerIntegrated digital control potentiometer
  • 128-Tap Positions128-tap position
  • 10kΩ, 50kΩ Total ResistanceIt is 10kΩ and the total resistance is 50kΩ
  • Monotonic Over TemperatureMonotonic overtemperature
  • Non-Volatile Wiper Position StorageNon-volatile storage of the slip position
  • 0 to VDD Terminal Voltage0 to VDD terminal voltage
• I²C Serial InterfaceI^{2 C}Serial interface
• 16kbit EEPROM16kbit EEPROM
  • 50 Years Retention @55°C50 years reserved@
  • 100,000 Cycles EnduranceCycle life 100,000
• Single 3.3 ±0.3V supplyThe single supply is 0.3V ± 3.3
• 3mm x 3mm Thin DFN Package – 0.8mm Max Thickness, 0.65mm PitchAvailable in a 3mm x 3mm thin DFN package - maximum thickness of 0.8mm, 0.65mm pitch
• Pb-Free Plus Anneal Available (RoHS Compliant)Lead-free plus annealed (RoHS compliant)

This device integrates a 128-tap digitally controlled potentiometer, 16kbit of EEPROM, and a 2-wire serial interface.The device integrates a 128-tap digitally controlled potentiometer, 16kbit of EEPROM, and a 2-wire serial interface. The device is powered by a single 3.3V supply.The device is powered by a single 3.3V supply. The potentiometer is available with total resistance of either 10kΩ or 50kΩ.Potentiometers with either a total resistance of 10kΩ or 50k are available.

The memory is organized in 128 pages of 16 bytes each, to reduce total programming time.Memory is organized into 128 pages of 16 bytes per page to reduce the total programming time. All programming signals are generated on-chip.All programming signals are generated on-chip.

The potentiometer is implemented with a combination of CMOS switches and resistor elements.A potentiometer is a combination of CMOS switches and resistive elements. The position of the wiper can be stored in non-volatile memory and then be recalled upon a subsequent power-up.The tap position can be stored in non-volatile memory and then recalled after subsequent power. The three terminals of the potentiometer are available for use as either a variable resistor or a resistor divider.The potentiometer's three terminals are available for use either as variable resistors or resistance dividers.