-
I 2 C compatible interface
- V OUT1 = step from 1V to 2V 50 mV
- V OUT2 = 1.8V to 3.3V 100 mV class
- Automatic PFM/PWM mode switching and PWM low-noise operation mode enforcement
-
The spread spectrum function uses I 2 comet
- 600 mAh load per channel
- 2 MHz Fixed Switching Frequency PWM (Typical)
- Internally synchronized rectification for high efficiency
- Internal soft start
- Two outputs of power-on reset function
-
2.7V ≤ V IN ≤ 5.5V
- It uses a single lithium-ion battery or 3 NiMH/NiCd batteries and a 3.3V/5.5V fixed rail
- 2.2μH inductor, 4.7μF input and output, 10μF capacitance per channel
- 16-Pin LLP Package (4 mm x 5 mm× 0.8 mm)
- 20-bump micro SMD package (3.0 mm× 2.0 mm× 0.6 mm)
illustrate
The LM3370 is a dual step-down DC-to-DC converter for driving ultra-low voltage circuits ranging from 2.7V to 5.5V input rails from a single lithium-ion battery. It provides two outputs per channel load of 600 mAh. The output voltage range is from 1V to 3.3V, and the use of I can be dynamically controlled 2 C compatible interface. This dynamic voltage amp capability enables the highest level of performance with the lowest power consumption of the processor. It's in me 2 The C-compatible interface can also be used to control performance-enhancing features such as automatic PFM-PWM/PWM mode selection.
The LM3370 offers superior functionality and the performance of a portable system for complex power management requirements. Intelligent switching between automatic PWM low noise and PFM low current modes provides improved system efficiency. Internal synchronous rectification improves efficiency without further external devices using the converter.
There is a power-on reset function to monitor the output voltage level to avoid unexpected power loss. Independently of each output enable pin allows for simple and efficient power sequencing.
The LM3370 is a micro SMD available in 4 mm, 5 mm, 16-pin non-pull LLP and 20 bump packages in 3.0 mm× 2.0 mm× 0.6 mm. The high switching frequency of 2 MHz (typical) allows for tiny surface-mount components, including a 2.2μH inductor.
2. The output voltage is a fixed voltage, and the default combination can be customized to meet the system requirements of contacting National Semiconductor Corporation.
apply
- Baseband treatment
- Application Processor (Video, Audio)
- I/O power supply
- FPGA and CPLD power supplies
|