LM3S1110-IQC25

illustrate

The Stellaris ® LM3S1110 microcontroller is based on ARM's ® Cortex-M3™ controller core operating at up to 25 MHz, with 64 KB of flash memory and 16 KB of SRAM. The LM3S1110 also features real-time industrial connectivity with an SSI/SPI controller, as well as 2 UARTs. Finally, LM3S1110 microcontroller offers a 24-bit SysTick timer, 3 32-bit or 6 16-bit universal timers, a watchdog timer, an RTC battery to support hibernate modules and 256 non-volatile state-saving bytes of memory, a low-dropout regulator so that only one supply voltage is required, an undervoltage reset, a power-on reset controller, and up to 41 GPIOs.

characteristic

• 32-bit ARM ® Cortex-M3™ 25 MHz instruction set processor core system timer (SysTick), integrated nested vector interrupt controller (NVIC), memory protection unit (MPU) and Thumb-2,

• Full-featured debugging debugging solutions via JTAG and serial line interfaces, as well as IEEE 1149.1-1990 access compatible Test Access Port (TAP) controllers

• 64 KB of single-cycle flash memory and 16 KB of single-cycle SRAM

• Low-power battery operation with real-time clock hibernation module

• 20-41 GPIOs (configuration dependent) with programmable control of GPIO interrupts and port configurations

• ARM FiRM compatible, watchdog timer; Plus three Universal Timer Modules (GPTMs), each providing two 16-bit timers/counters, which can be configured to operate independently

• 10-bit analog-to-digital converter (ADC) with analog input channels and a sample/sec sample rate

• Two fully programmable 16C550 UARTs with IrDA S support

• Synchronous Serial Interface (SSI) for Freescale SPI, MICROWIRE, or Texas Instruments Synchronous Serial Interface operation

• The outputs of the two integrated analog comparators can be configured to drive the output pins or generate interrupts

• Industrial and extended temperature RoHS compliant 100-pin LQFP package, industrial scope RoHS compliant 108-ball BGA package