- Easily drive 600Ω loads
- Superior audio signal fidelity is optimized
- Output short-circuit protection
- PSRR and CMRR over 120 dB (typical)
- SOIC, DIP, TO-99 metal can be packed
illustrate
LME49720 is part of an ultra-low distortion, low noise, high slew rate op amp series, high performance, high fidelity applications, fully optimized and specified. Combined with the state-of-the-art circuit design and advanced cutting-edge process technology, LME49720 audio op amplifier can provide excellent audio performance and superior audio signal amplification. LME49720 combined with very low voltage-noise density (2.7nV/) √ ^Hz) with a very low THD + N (0.00003%), easily meeting the most demanding audio applications. To ensure that the most challenging loads are uncompromising drives, LME49720 boasts a high slew rate of ±20V/μs and an output current capability of ±26 milliamps. In addition, the dynamic range is maximized, driving the output stage when driving a 600Ω load within 1V and 1.4V of either supply voltage over a 2kΩ load range.
LME49720 excellent CMRR (120 dB), (PSRR120 dB) and V OS (0.1mV) amplifiers for excellent operational amplifier DC performance.
LME49720 has a wide supply voltage range ± 2.5V to ± 17V. LME49720 input circuitry maintains excellent common-mode and supply rejection over this supply voltage range, as well as maintaining its low input bias current. LME49720 is stable unit gain. This op-amp achieves excellent AC performance with high values of up to 100pF for complex loads while driving.
LME49720 are available in an 8-pin narrow-body SOIC package, an 8-pin plastic DIP, and an 8-lead metal can TO-99. Each package presentation board.
Key specifications:
|
■ Supply voltage range
|
± 2.5V to ± 17V
|
|
■ (When V = 1 for THD + N, V IN, OUT = 3V RMS, F = 1kHz)
|
|
|
R L = 2kΩ
|
0.00003% (typical)
|
| R L =600Ω |
0.00003% (typical)
|
|
■ Input noise density
|
2.7nV / √ ^ Hz (typical)
|
|
■ Swing rate
|
± 20V/μs (typical)
|
|
■ Gain bandwidth accumulation
|
55MHz (typical)
|
|
■ Open-loop gain (R L = 600Ω)
|
140 dB (typical)
|
|
■ Input bias current
|
10nA (typical)
|
|
■ Input offset voltage
|
0.1mV (typical)
|
|
■ DC gain linear error
|
0.000009％ |
apply
- Ultra-high-quality audio amplification
- High-fidelity preamp
- High-fidelity multimedia
- National Art Phono Ampere in front of the camera
- High-performance professional audio
- High-fidelity equalization and crossover networking
- High-performance line drivers
- High-performance line receiver
- High-fidelity active filters
|