LMV716MM

• Product Introduction

 peculiarity (Typical, V + = 3.3V, T A = 25 °C, unless otherwise specified) Input noise voltage 12.8 NV / Input bias current 0.6 pA Offset voltage 1.6 millivolts Common Mode Rejection Ratio (CMRR) Up to 80 dB Open-loop gain 122 dB Rail-to-rail output GBW 5 MHz Swing rate 5.8 V/μs Supply current 1.6 mA Supply voltage range 2.7V to 5V Operating temperature -40°C to 85°C 8-pin MSOP package illustrate The LMV716 is a dual op amp with two low voltage and low supply currents, making it ideal for portable applications. The LMV716 CMOS input stage driver I bias current drops to 0.6 pA, which with a low noise voltage of 12.8 plus NV/NV/make the LMV716 perfect for applications with active filters, resistive amplifiers, and hard disk vibration cancellation circuitry. With high noise sensitivity, small signal applications will benefit from a bandwidth of 5 MHz with a large gain, coupled with a minimum supply current of 1.6 mA and a slew rate of 5.8 V/μs. The LMV716 provides heavy rail-to-rail output swing. The input common-mode voltage range includes ground, which is ideal for ground-based remote sensing applications. The LMV716 has a supply voltage ranging from 2.7V to 5V and is available in an 8-pin MSOP package with a wide temperature range of -40°C to 85°C. This allows it to be placed next to the LMV716 small package of the sensor, reducing external noise pickup.   apply Active filter Impede amplifier Audio preamp Hard disk vibration cancellation circuit