• Product Introduction

LT1032ISW

Four low-power line drivers

peculiarity Low operating voltage: ± 5V to ± 15V 500μA supply current When the power is turned off at zero, the power supply current The output can drive ± 30V Heat limit When outputting "on", off (three states) 10mA output driver The pin is similar to 1488 ® The LT 1032 is an RS232 and RS423 line driver that operates over a low supply current range of ± 5V to ± 15V and can shut down to zero supply current. The output is fully protected ± 30V externally applied voltage, current, and thermal limits. The need for power supply is minimized due to the fluctuation range of 200mV with output positive and negative supply voltages of 600mV. A strobe pin is also included to force the independence of low input or shutdown conditions for all outputs. In addition, the slew rate can be adjusted by one resistor to connect to the power supply. The main advantage of an LT1032 is that it can be powered off or powered off when in a high-impedance output state. For applications requiring dual or triple RS-232 drives/receiving devices, see LT1180A (dual), LT1039A (triple), or LT1130A datasheets