LT1308IS8

• Product Introduction

LT1308IS8 high-current, micro-power, single-cell, 600kHz DC/DC converter

peculiarity

• 单锂离子电池可在 1A 电流提供 5V 电压
• 四个镍镉电池可在 SEPIC 方式下提供 5V 电压和 800mA 电流
• 固定工作频率：600kHz
• 高达 34V 的升压变换器输出
• 大负载起动
• 轻负载条件下的自动突发方式 (Burst Mode^®) 操作 (LT1308A)
• 轻负载条件下的连续转换 (LT1308B)
• 低 V_CESAT 开关：300mV/2A
• 与 LT1308 引脚升级兼容
• 停机状态下静态电流较小：1µA (最大值)    
• 准确度更高的低电池电量检测器基准：200mV ±2%
• 采用 8 引线 SO 和 14 引线 TSSOP 封装

description

®The LT 1308A / LT1308B is a micro-power, fixed-frequency boost DC/DC converter that operates from a 1V to 10V input voltage range. They are an improved version of the LT1308 and are recommended for use in a variety of new designs. LT1308A automatically transitions to an energy-efficient burst mode of operation at light loads and consumes only 140μA at no load. The LT1308B, on the other hand, is capable of continuous conversion at light loads and operates at a quiescent current of 2.5mA. Both devices consume less than 1μA in downtime.

The low battery level detector is significantly more accurate than the LT1308. The 200mV reference at room temperature is specified at ±2% and ±3% over the entire operating temperature range. The shutdown pin enables the device when connected to a 1V or higher voltage source (rather than the VIN as it was on the LT1308). An internal VC clamping circuit improves transient response and increases the switching voltage rating to 36V, allowing for applications with higher output voltages.

The LT1308A/LT1308B are available in 8-lead SO and 14-lead TSSOP packages.