• Product Introduction

LT1636IS8

Micro-over-top rail-to-rail input and output op-amps

peculiarity

• Rail-to-rail inputs and outputs
• Micro: 50μAI Q, 44V supply
• Operating temperature range: - 40°C to 125°C
• Excessive Popularity ®: 44V input common mode range over V EE, independent V CC
• Low input offset voltage: 225μV max
• Specified 3V, 5V, and ± 15V power supplies
• High Output Current: 18mA
• Cut off the output
• The output driver output compensates for 10,000 pF
• Reverse battery protection up to 27V
• High voltage gain: 2000V/mV
• High CMRR: 110 dB
• Product of gain bandwidth at 220kHz
• 8-pin DFN and MSOP, PDIP, and SO packages

description

® The LT 1636 op amp operates on all single and total voltages from 2.7V to 44V for drawing quiescent current and splitting supplies of less than 50μA. The LT1636 can be shut down to enable high impedance of the output and reduce quiescent current by 4μA. The LT1636 has a unique input stage that operates and maintains a high impedance above the positive supply. Input 44V differential and common mode, even when a 3V supply is operating. The output swing of the two power supplies. Unlike most micropower op amps, the LT1636 can drive heavy loads; Its rail-to-rail output driver is 18 mAh. The LT1636 is used in a 0.22μF and 150 ohm compensated network when the unit gain stabilizes to capacitive loads up to 10,000 pF.

The LT1636 is a reverse supply guarantee: there is no current in the shot reverse supply to 27V. Built-in resistance below the fault-protected input with a negative supply voltage of up to 22V. If there is no VEE or a 44V input below 5V or more VEE, the output phase reversal of the independent V CC.

The LT1636 op-amp is available in 8-pin MSOP, PDIP, and SO packages. For space-constrained applications, the LT1636 is available in a 3mm x 3mm ×0.8mm dual fine-pitch lead-free package (DFN).