TAS5352A

illustrate

The TAS5352A is a high performance, integrated stereo digital amplifier power stage designed to drive up to 4Ω bridge load (BTL) to 125 watts per channel with low harmonic distortion, low noise integrated and low standby current.

The TAS5352A has a complete protection system integrated chip, and failure to guarantee conditions can damage the entire system-wide equipment. These protection features include short-circuit protection, overcurrent protection, under-voltage protection, over-temperature protection, and loss of pulse-width modulated signals (PWM activity detectors).

A power-on reset (POR) circuit is used to eliminate the sequencing of power supplies, which is required for most power stage designs.

characteristic

• Total output power (parallel load bridge)
  • 2×125 at 10% THD width + N is 4Ω
  • 2 × 100 at 10% THD width + N is 6Ω
• Total output power (single-ended)
  • 4 × 45 10% THD width + N is 3Ω
  • 4 × 35 10% THD width + N is 4Ω
• Total output power (parallel mode)
  • 1 × 250 at 10% THD width + N is 2Ω
  • 1 × 195 at 10% THD width + N is 3Ω
• > 110 dB signal-to-noise ratio (A weighted with TAS5518 modulator)
• "0.1% THD+N (1 watt, 1 kHz)
• Supports a PWM frame rate of 192 kHz
  432 kHz
• Resistor programmable current limit
• Integrated self-protection circuitry, including:
  • Undervoltage protection
  • Overheating warnings and errors
  • Overload protection
  • Short-circuit protection
  • PWM for activity detectors
• Independent protection recovery