TAS5710

illustrate

The TAS5710 is a 20-watt, high-efficiency, digitally driven stereo bridge speaker audio power amplifier. A 32-bit data channel eliminates the need for pre-processing expansion and retains signal integrity without sacrificing dynamic range. The digital filter with a fully programmable digital audio processor enables designers to customize the best tone speaker in a small chassis. A programmable DRC can adjust an expandable design power level while also enabling night mode listening mode.

The closed-loop architecture allows the device to work poorly managed supplies. When the feedback architecture in Figure 1 below benefits, the noisy supply (500mVpp ripple at 1kHz) is modulated into a 10kHz audio input.

characteristic

• Audio input/output
  • An 8 Ω load at 20 W is supplied from an 18 V supply
  • Wide PVCC range (10 V to 26 V)
  • Supports one serial audio input (8 kHz - 48 kHz sample rate) (chick/RJ/i^{2 seconds}）
  • Power level feedback can be derived from poorly managed regulated power supplies
• Audio/pulse width modulation processing
  • Factory-calibrated automatic rate detection of internal oscillators
  • High-end 32-bit data channel audio processor
  • 18 speaker equalization second-order filter
  • Dynamic range control (gold)
  • Supports pseudo-bass and 3D effects
• merit
  • Emotional intelligence: Speakers get better tonal balance
  • 2-band DRC: Improves bass effect, makes speakers hearing protection and night mode
  • Autobank Switch: Three different sample rate coefficients, no need to pre-install update the sample rate when the coefficient changes
  • Automatic detection: Automatic detection of sample rate changes by external microprocessor intervention is not required
  • Closed-loop power stage: Opens up a wide PVCC operating range and reduces power supply ripple distortion