illustrate

The TAS5717/TAS5719 are 10-W/15-W, high efficiency, digital audio power driven stereo bridge speaker amplifiers. One serial data input allows processing of up to two independent audio channels and seamless integration into most digital audio processors and MPEG decoders. The device accepts input data and various data rates. A fully programmable data path routes these internal speaker driver channels.

The TAS5717/9 is a slave's only device that receives all clocks from external sources. Operating TAS5717/TAS5719 has a switching frequency of 384 kHz and a switching frequency of 352 kHz, the input sampling rate depends on the PWM carrier. Oversampling combined with a fourth-order noise shaper provides a noise floor in units from 20 Hz and excellent dynamic range of 20 kHz.

characteristic

• Audio input/output
  • The TAS5717 supports 2 × 10 W and the TAS5719 supports 2 × 15 W output
  • Wide PVDD from 4.5 V range to 26 V
  • Efficient Class D operation eliminates the need for a heatsink
  • Only 3.3 volts and PVDD are required
  • One serial audio input (two audio channels)
  • I via PIN^{2 C}Address selection (film selection)
  • Supports sample rates from 8 kHz to 48 kHz (chicks/RJ/i^{2 seconds}）
  • External headphone amplifier shutdown signal
  • Integrated capacitorless headphone amplifier
  • Stereo headphones (line driver for stereo 2-V RMS) output
• Audio/pulse width modulation processing
  • Independent channels provide 24 dB volume control, mute
  • Programmable two-band dynamic range control
  • 14 Speaker's EQ programmable second-order filter
  • Design rules check filter programmable coefficients
  • DC barrier filter
  • 0.125 dB fine volume support
• General characteristics
  • Serial control interface, not MCLK services