TLC372-EP

• Product introduction

This device is fabricated, using LinCMOS™ technology and two independent voltage comparators, designed to work on a single power supply for each component. Operation from dual supplies is also possible, and if the two are compared, the difference is 4 V to 18 five, each with extremely high input impedance (typically greater than 10).¹² ), allowing direct connection of high impedance sources. The output is an N-channel open-drain configuration that can be connected for positive logic wires and relationships.

The TLC372 has an internal electrostatic discharge (ESD) protection circuit and has been graded with a 2000-V electrostatic discharge using the Human Body Model (HBM) test. However, we should be especially careful to handle contact electrostatic discharge that may cause degradation of the performance parameters of this device.

The TLC372 is characterized by operation at -55°C to 125°C

characteristic

• Control baselines
  • One package/test site, one production site
• Extended -55°C temperature to 125°C performance
• Enhanced support for decreasive manufacturing sources (DMS).
• Enhanced product change notifications
• Qualification genealogy^（1）
• ESD protection over 2000 volts according to MIL - STD - 883, Method 3015; More than 100 V using the machine model (C = 200 pF, R = 0)
• Single or dual power supply
• Wide supply voltage range. 。 0.4 V to 18 V
• Very low supply current consumption. 。 0.150 μA typical at 5 V
• Fast response time. 。 。 200 nanoseconds typical TTL level input step
• Built-in ESD protection
• High input impedance. 。 。 10¹² typical
• Very low input bias current. 。 0.5 pA typical
• Ultra-stable low input offset voltage
• The worst-case conditions for input voltage variation in input offset are typically 0.23μV/month, including the first 30 days
• The common-mode input voltage range includes ground
• The outputs are compatible with TTL, MOS tubes, and CMOS
• Pin compatible, LM393

parameter