• Product Introduction

TPIC2603 

6-channel serial interface low-side driver

illustrate   The TPIC2603 is a monolithic low-side driver that provides a serial interface and diagnostics to control the power supply DMOS switch on the six-board. Each channel has independent shutdown state open-circuit load sensing, national short-load/short-to-battery protection, over-battery voltage lockout protection, over-temperature sensing and fault status are reported through the serial interface. The device also provides inductive voltage transient protection for each leak output. This TPIC2603 drives such as relays, valves, lamp inductors, and resistive loads. Serial Data Input (SDI) is the conversion of the CS\Low Serial Clock (SCLK) low to high when the CS\ is the Low Serial Clock (SCLK) transfer via serial registers. Each data string must be made up of 8 or 16 bits of data.   characteristic   Serial control and diagnostics Six power DMOS transistors output 350 mA of continuous current Built-in 60 - V inductive load clamp About Independent Countries Shorted-Load/Short-to-Battery Fault detection of all drainage stations Independent shutdown state for all drainage station fault detection on open loads The leakage output transitions to low duty cycle pulse width modulation (PWM) mode overcurrent conditions Over battery voltage lockout protection Over-temperature detection, serial interface fault status Fault diagnosis returns home through serial output terminals Internal power-up reset register Hysteresis CMOS compatible inputs