TPS386000RGPT

illustrate

The TPS3860x0 home can monitor four power rails in the supply (SVSs) voltage monitoring, one is greater than 0.4V and 0.4V with less than 0.25% (typical) threshold accuracy (including negative voltage). Each of the four supervisory circuits (SVS) asserts that RESETn or RESETn outputs a signal when the SENSEm input voltage falls below the set threshold. Using an external resistor, the threshold of N per SVS can be programmed (where n = 1, 2, 3, 4 and M = 1, 2, 3, 4 l, 4 h).

Each SVS-n has a programmable delay or RESETn before release. The delay time can be set independently for each SVS from 1.4 ms to 10 s connected via troponin needles. Only SVS-1 has a low-level valid manual reset (MR) input, and a logical low-input councilor asserts RESET1 or RESET1.

characteristic

• Four independent voltage monitors
• Channels 1, 2, 3: Adjustable thresholds as low as 0.4V
• Channel 4: Adjustable threshold at any positive/negative voltage
• Adjustable Latency: 1.4ms to 10s
• Threshold accuracy: 0.25% typical
• Very low quiescent current: 11μA typical
• Channel 1: Manual Reset (MR) Input
• Channel 4: Window Comparator
• Watch Dog Timer Output Strap Special
• A well-controlled output is on power-up
• TPS386000: Leak open road RESETn and waste disposal regulations
• TPS386020: Leak open road RESETn and waste disposal regulations
• TPS386040: Push and pull RESETn and waste disposal regulations
• TPS386060: Push and pull RESETn and waste disposal regulations
• Package: 4mm x 4mm, 20-pin QFN

• apply

• All DSP and microcontroller applications
• All FPGA/ASIC applications
• Telecom/wireless infrastructure
• Industrial equipment