TPS54611

illustrate

In SWIFT's™ DC/DC regulator series, TPS54611, TPS54612, TPS54613, TPS54614, TPS54615 and TPS54616 low input voltage high output current synchronous step-down PWM converters incorporate all the required active ingredients. Included on the substrate is a real, high-performance, voltage-error amplifier that provides high performance under transient conditions, with undervoltage latching circuitry that prevents start-up until the input voltage reaches 3 volts; An internal and external setup slow-start circuit limits inrush current, and a power supply good output processor/logic reset is useful, fault signal and power supply sequencing.

The TPS54611-6 device uses a thermally enhanced 28-pin TSSOP (Public Works) PowerPAD™ package, eliminating bulky heat sinks.

characteristic

• 30 meters 12 – A high-efficiency MOSFET peaks at 6-A continuous output source switch and receiver
• 1.0% initial accuracy for 0.9 volts, 1.2 volts, 1.5 volts, 1.8 volts, 2.5 volts, and 3.3 V fixed output voltage devices
• Internal compensation for ease of use and minimum number of components
• Fast transient response
• Wide PWM Frequency - Fixed 350 kHz, 550 kHz or 280 kHz to 700 adjustable kHz
• Protect the load by peak current limiting and thermal shutdown
• Comprehensive solutions reduce board area and total cost
• apply
  • At low voltages, high-density systems are distributed at 5 V or 3.3 V
  • High-performance DSP, FPGA, ASIC, and microprocessor regulations for the point of load
  • broadband, optical communication networks and infrastructure
  • Laptop/laptop