TPS60141

illustrate

The TPS6014x boost, regulated charge pump generates an input voltage range of 3.6 V from 1.8 V to 5 V ± 4% output voltage. These devices are usually made up of two alkaline batteries, NiC, NiMH or supplied with at least 100 mA from a 2-V input and output. Only four external capacitors are required to set up a complete triple frequency voltage charge pump.

The device uses adjustment pulses to skip the output of the topology. The controller is optimized to output the full minimum output voltage ripple current range. Output peak current, therefore, output voltage ripple is greatly reduced compared to traditional pulses skipping the topology of adjusting the output impedance of a charge pump. The maximum output resistance at light loads is limited to ensure low quiescent current.

characteristic

• The regulated 5 volt output voltage is ± 4%, up to 100 mA output current for an input voltage range of 1.8 V to 3.6 V
• Quiescent current of 65 uA
• 0.05 - Microamp standby current, battery is isolated from load shutdown
• Integrated low battery or power good indicator
• Low output voltage ripple over the full output current range
• Easy to design with low EMI power inductors because it is not necessary
• Evaluation module available (TPS60140EVM - 144)
• apply
  • As battery-powered application inductors replace DC/DC converters:
    • Two battery cells are converted to 5 V
    • Portable instrument
    • Small devices
    • Backup battery boost converter
    • Medical devices
    • 5-V smart card supply
    • Organizer, personal digital assistant