The IC-1868 series of UC1861 is best suited for the control of zero-current switching and zero-voltage switching quasi-resonant converters. This differs from UVLO's threshold and output selection to the members of the various combinations of device family results. In addition, a single-pulse steering logic configuration scheme is configured for either zero-current systems at the time (UC1865-1868) or zero-voltage switching applications at off-time (UC1861-1864).
The main control module implementation consists of an error amplifier to compensate for the entire system cycle, driving a voltage-controlled oscillator (VCO) with programmable minimum and maximum frequencies. Triggered by the VCO, the maximum width of one program is generated at a time, and zero-modulated pulses can be compared by detection.
characteristic
- Control a zero-current switch (zero-current) or zero-voltage switch (zero-voltage switch) quasi-resonant converter
- Zero crossing terminates a single-shot trigger timer
- 1% accuracy, soft-start 5V reference
- Programmable delay after reboot failure
- Voltage controlled oscillator (VCO) and programmable minimum and maximum frequencies from 10kHz to 1MHz
- Low Start-up Current (150μA Typical)
- Dual 1 amp peak FET drivers
- UVLO options are available for offline or DC/DC applications
parameter
|
|
|
UC3863 |
topology |
|
|
Full bridge, half bridge, push and pull |
Control method |
|
|
Voltage mode |
Duty cycle (max.) (%) |
|
|
50 |
Frequency (max) (khertz) |
|
|
450 |
On/Off of Undervoltage Lockout Threshold (5) |
|
|
8 / 7 |
Pins/Packets |
|
|
16PDIP,16SOIC |
(#) Regulated output |
|
|
2 |
Operating temperature range(°C) |
|
|
0 to 70 |
Microchip Centennial Electronic Technology (Shenzhen) Co., Ltd
Address: Shenzhen Futian District Huaqiang Road Huaqiang Plaza A Block 13H
Tel: 0755-83591082
Fax: 0755-83591083
Q Q:1051085817
//www.chip100.com/