home page>Product Center> ACDC- and -DCDC-power supplies
UCC28083
Product images are for illustrative purposes only
Product details are welcome upon request

UCC28083

  • Category:ACDC- and -DCDC-power supply
  • Product Name:Current-mode push-pull PWM with programmable slope compensation
  • Manufacturers:TI
  • Production Batch Number:09+
  • Encapsulation:8PDIP, 8SOIC, 8TSSOP
  • Stock Status:There is stock
  • Stock Quantity:6000
  • Minimum order quantity: 1
  • Details:点击查找UCC28083的pdf资料
  • Click Request a quote
Contact usOnline customer service1 Online customer service2 Click Send email
  • Product introduction

The UCC38083/4/5/6 is a family of BiCMOS pulse-width modulated (PWM) DC-to-DC or offline fixed-frequency current mode switching power supply controllers. This dual output stage is configured for a push-pull topology. Half of the oscillators of the two output switches use the frequency of a switching trigger. The dead time between the two outputs is typically 110 nanoseconds, limiting the duty cycle of each output to less than 50%.

The new UCC3808x family is based on the UCC3808A architecture. Key differences include a programmable slope compensation ramp to the CS signal and the addition of error amplifiers. The ISET pin now flows out through an external resistor to set the severity of the ramp compensation function monitored internally.

characteristic
 
  • Programmable slope compensation
  • Internal soft start UCC38083/4
  • Cycle-by-cycle current limit
  • Typical operation with low start-up currents of 120 μA and 1.5 mA
  • External component oscillators are programmable from 50 kHz to 1 MHz
  • High current totem pole output stage driver with dual push-pull 1-one receiver and 0.5-A source configuration capability
  • Current sense discharge transistors to improve dynamic response
  • Internal fine-tuning bandgap reference
  • Undervoltage lockout and hysteresis
  • apply
    • High efficiency switch-mode power supply
    • Telecom DC-DC converters
    • Point load or point of available power supply modules
    • Low-cost push-pull and half-bridge applications
parameter
  UCC28083  
topology Half bridge, push and pull  
Control method Current mode  
Duty cycle (max.) (%) 50  
Frequency (max) (khertz) 1000  
On/Off of Undervoltage Lockout Threshold (5) 12.5/8.3  
Pins/Packets 8PDIP,8SOIC,8TSSOP  
(#) Regulated output 2  
Operating temperature range(°C) -40 to 85  

andUCC28083Related ICs are:


Model Manufacturers lot number encapsulation illustrate
UCC28083 TI 09+ 8PDIP, 8SOIC, 8TSSOP Current-mode push-pull PWM with programmable slope compensation
UCC28083D TI 0831+ SOIC-8  

Popular searches


Model Manufacturers lot number encapsulation illustrate
PW70d(2x10432Ω/83°) FSG 2023+ potentiometer PW70D(2*1043Ω 1%/83°)(1700Z04-257.106)
PW70d FSG 2023+ potentiometer PW70D(2*1043Ω 1%/83°)(1700Z04-257.106)
S34ML16G202BHI000 Flip Electronics 2051+ 63BGA 16 Gb, 3 V, 4-bit ECC, x8 I/O, SLC NAND Flash Memory for Embedded
FRCIR06RGG18-20S-F80-V0-M20-1.5F ITTVEAM 2023+ connector Connectors, Circular Connectors, Circular Plugs & Receptacles
CL1215-02P72ET-U2 Schaltbau 2023+ Contactors CL1215/02 P 72ET-U2 1, 2 and 3 pole AC and DC NO contactors for voltages up to 1,500 V
CL1115-02P72ET-U2 Schaltbau 2023+ Contactors 1, 2 and 3 pole AC and DC NO contactors for voltages up to 1,500 V
D-U204N-KLGQ Mors Smitt 2023+ Relays No magnetic arc blow-out
D-U204N-KLCQ Mors Smitt 2023+ Relays No magnetic arc blow-out
MIP30F00830-S1048 Amphenol Positronic 2023+ connector MIP series connectors
C163C/110EV-R1 Schaltebao 2023+ Contactors Contactors
F670-H4V-XUU LEACH 2023+ Relays F670-H4V-XUU+SHKE470-110-AD
F670-H4VP-XUXU LEACH 2023+ Relays F670-H4VP-XUXU+SFE670-1-1
AZ16-12ZI-B1-1747-M20 SCHMERSAL 2023+ switch Safety switches
RX2025GE1 Surio 2023+ connector Extract, Remove, and Insert Tools Contact extraction tool #16
5106.021.09.24 Surio 2023+ connector Extract, remove, and insert tools Extract tool with pop-up
ABMPSE06T28M4SV0N AB Connectors 2023+ connector Plug with RFI Ground
ABMPSE06T36M2SV0N AB Connectors 2023+ connector Plug with RFI Ground
ABMP18T28M13SV0N AB Connectors 2023+ connector RAIL AND MILITARY LAND SYSTEMS
ABCIRHSE06JE1812SCNF80M32V0 AB Connectors 2023+ connector Halogen Free Bayonet Lock Connector Series
TSW-101-06-LM-D samtec 2023+ connector Classic PCB Header Strips, 0.100" pitch

TI brand product recommendation


Model Manufacturers lot number encapsulation illustrate
UCC2808-2 TI 10+ 8PDIP, 8SOIC Low power current mode push-pull PWM
UCC2808-1 TI 10+ 8PDIP, 8SOIC Low power current mode push-pull PWM
UCC2807-3 TI 10+ 8SOIC Programmable maximum duty cycle PWM controller
UCC2807-2 TI 10+ 8PDIP, 8SOIC Programmable maximum duty cycle PWM controller
UCC2807-1 TI 07+ 8PDIP, 8SOIC Programmable maximum duty cycle PWM controller
UCC2806 TI 07+ 16PDIP, 16SOIC, 16SSOP/QSOP, 16TSSOP, 20PLCC Low power, dual output, current mode PWM controller
UCC2805-Q1 TI 10+ 8SOIC Automotive low-power BiCMOS current-mode PWM
UCC2805 TI 10+ 8PDIP, 8SOIC, 8TSSOP Automotive low-power BiCMOS current-mode PWM
UCC2804 TI 09+ 8PDIP, 8SOIC, 8TSSOP Low power BiCMOS current mode PWM
UCC2803-Q1 TI 10+ 8SOIC Automotive low-power BiCMOS current-mode PWM
UCC2803 TI 09+ 8PDIP, 8SOIC, 8TSSOP Low power BiCMOS current mode PWM
UCC2802-Q1 TI 10+ 8SOIC Automotive low-power BiCMOS current-mode PWM
UCC2802 TI 10+ 8PDIP, 8SOIC, 8TSSOP Low power BiCMOS current mode PWM
UCC2801-Q1 TI 10+ 8SOIC Automotive low-power BiCMOS current-mode PWM
UCC2801 TI 09+ 8PDIP, 8SOIC, 8TSSOP Low power BiCMOS current mode PWM
UCC2800-Q1 TI 10+ 8SOIC Automotive low-power BiCMOS current-mode PWM
UCC2800 TI 09+ 8PDIP, 8SOIC, 8TSSOP Low power BiCMOS current mode PWM
UCC2583 TI 10+ 14PDIP, 14SOIC, 20PLCC Switch-mode secondary-side post-regulator
UCC2581 TI 09+ 14SOIC Micropower voltage mode PWM
UCC25706 TI 08+ 8MSOP, 8PDIP, 8SOIC High speed voltage mode pulse width modulator

Categorical search