home page>Product Center> ACDC- and -DCDC-power supplies
UCC28086
Product images are for illustrative purposes only
Product details are welcome upon request

UCC28086

  • Category:ACDC- and -DCDC-power supply
  • Product Name:Current-mode push-pull PWM with programmable slope compensation
  • Manufacturers:TI
  • Production Batch Number:10+
  • Encapsulation:8PDIP, 8SOIC, 8TSSOP
  • Stock Status:There is stock
  • Stock Quantity:2502
  • Minimum order quantity: 1
  • Details:Click here to find PDF information on UCC28086
  • Click Request a quote
Contact usOnline customer service1 Online customer service2 Click Send email
  • Product introduction

The UCC38083/4/5/6 is a family of BiCMOS pulse-width modulated (PWM) DC-to-DC or offline fixed-frequency current mode switching power supply controllers. This dual output stage is configured for a push-pull topology. Half of the oscillators of the two output switches use the frequency of a switching trigger. The dead time between the two outputs is typically 110 nanoseconds, limiting the duty cycle of each output to less than 50%.

The new UCC3808x family is based on the UCC3808A architecture. Key differences include a programmable slope compensation ramp to the CS signal and the addition of error amplifiers. The ISET pin now flows out through an external resistor to set the severity of the ramp compensation function monitored internally.

characteristic
 
  • Programmable slope compensation
  • Internal soft start UCC38083/4
  • Cycle-by-cycle current limit
  • Typical operation with low start-up currents of 120 μA and 1.5 mA
  • External component oscillators are programmable from 50 kHz to 1 MHz
  • High current totem pole output stage driver with dual push-pull 1-one receiver and 0.5-A source configuration capability
  • Current sense discharge transistors to improve dynamic response
  • Internal fine-tuning bandgap reference
  • Undervoltage lockout and hysteresis
  • apply
    • High efficiency switch-mode power supply
    • Telecom DC-DC converters
    • Point load or point of available power supply modules
    • Low-cost push-pull and half-bridge applications
parameter
  UCC28086  
topology Half bridge, push and pull  
Control method Current mode  
Duty cycle (max.) (%) 50  
Frequency (max) (khertz) 1000  
On/Off of Undervoltage Lockout Threshold (5) 4.3/4.1  
Pins/Packets 8PDIP,8SOIC,8TSSOP  
(#) Regulated output 2  
Operating temperature range(°C) -40 to 85  

andUCC28086Related ICs are:


Model Manufacturers lot number encapsulation illustrate
UCC28086 TI 10+ 8PDIP, 8SOIC, 8TSSOP Current-mode push-pull PWM with programmable slope compensation

Popular searches


Model Manufacturers lot number encapsulation illustrate
ABCIRHSE06HC2214PCWF80 AB 2023 connector Connector Kit ABCIRH Series Connector Assemblies Brand New Original Imported International Stock
AS7C4096A-15JIN Alliance Memory Inc 23+ SOJ-36 AS7C4096A Series 4-Mbit (512 K x 8) 5 V 15 ns CMOS Static RAM - SOJ-36
US-625AXTLQE ASAHI KEIKI 2023+ weld Temperature sensor
V23154D735B110 TE 2023+ Relays Low Signal Relay - PCB V23154D 735B110
V23154D735F104 TE 23+ Relays Signal Relays, 250 VDC Contact Voltage, 250 VAC Contact Voltage, 806 mW Coil Power (DC), Printed Circuit Board, PCB-THT, Axicom Cradle Relay N
AZ16-12ZIBI-1747-M20 SCHMERSAL 2023+ switch Safety gate switch
PW70d(2x10432Ω/83°) FSG 2023+ potentiometer PW70D(2*1043Ω 1%/83°)(1700Z04-257.106)
PW70d FSG 2023+ potentiometer PW70D(2*1043Ω 1%/83°)(1700Z04-257.106)
S34ML16G202BHI000 Flip Electronics 2051+ 63BGA 16 Gb, 3 V, 4-bit ECC, x8 I/O, SLC NAND Flash Memory for Embedded
FRCIR06RGG18-20S-F80-V0-M20-1.5F ITTVEAM 2023+ connector Connectors, Circular Connectors, Circular Plugs & Receptacles
HRF-AT4521-FL-TR Honeywell 10+11+ SMD RF ATTENUATOR 50OHM 16VQFN
CL1215-02P72ET-U2 Schaltbau 2023+ Contactors CL1215/02 P 72ET-U2 1, 2 and 3 pole AC and DC NO contactors for voltages up to 1,500 V
CL1115-02P72ET-U2 Schaltbau 2023+ Contactors 1, 2 and 3 pole AC and DC NO contactors for voltages up to 1,500 V
D-U204N-KLGQ Mors Smitt 2023+ Relays No magnetic arc blow-out
D-U204N-KLCQ Mors Smitt 2023+ Relays No magnetic arc blow-out
MIP30F00830-S1048 Amphenol Positronic 2023+ connector MIP series connectors
C163C/110EV-R1 Schaltebao 2023+ Contactors Contactors
F670-H4V-XUU LEACH 2023+ Relays F670-H4V-XUU+SHKE470-110-AD
F670-H4VP-XUXU LEACH 2023+ Relays F670-H4VP-XUXU+SFE670-1-1
AZ16-12ZI-B1-1747-M20 SCHMERSAL 2023+ switch Safety switches

TI brand product recommendation


Model Manufacturers lot number encapsulation illustrate
UCC28085 TI 10+ 8PDIP, 8SOIC, 8TSSOP Current-mode push-pull PWM with programmable slope compensation
UCC28084 TI 10+ 8PDIP, 8SOIC, 8TSSOP Current-mode push-pull PWM with programmable slope compensation
UCC28083 TI 09+ 8PDIP, 8SOIC, 8TSSOP Current-mode push-pull PWM with programmable slope compensation
UCC2808-2 TI 10+ 8PDIP, 8SOIC Low power current mode push-pull PWM
UCC2808-1 TI 10+ 8PDIP, 8SOIC Low power current mode push-pull PWM
UCC2807-3 TI 10+ 8SOIC Programmable maximum duty cycle PWM controller
UCC2807-2 TI 10+ 8PDIP, 8SOIC Programmable maximum duty cycle PWM controller
UCC2807-1 TI 07+ 8PDIP, 8SOIC Programmable maximum duty cycle PWM controller
UCC2806 TI 07+ 16PDIP, 16SOIC, 16SSOP/QSOP, 16TSSOP, 20PLCC Low power, dual output, current mode PWM controller
UCC2805-Q1 TI 10+ 8SOIC Automotive low-power BiCMOS current-mode PWM
UCC2805 TI 10+ 8PDIP, 8SOIC, 8TSSOP Automotive low-power BiCMOS current-mode PWM
UCC2804 TI 09+ 8PDIP, 8SOIC, 8TSSOP Low power BiCMOS current mode PWM
UCC2803-Q1 TI 10+ 8SOIC Automotive low-power BiCMOS current-mode PWM
UCC2803 TI 09+ 8PDIP, 8SOIC, 8TSSOP Low power BiCMOS current mode PWM
UCC2802-Q1 TI 10+ 8SOIC Automotive low-power BiCMOS current-mode PWM
UCC2802 TI 10+ 8PDIP, 8SOIC, 8TSSOP Low power BiCMOS current mode PWM
UCC2801-Q1 TI 10+ 8SOIC Automotive low-power BiCMOS current-mode PWM
UCC2801 TI 09+ 8PDIP, 8SOIC, 8TSSOP Low power BiCMOS current mode PWM
UCC2800-Q1 TI 10+ 8SOIC Automotive low-power BiCMOS current-mode PWM
UCC2800 TI 09+ 8PDIP, 8SOIC, 8TSSOP Low power BiCMOS current mode PWM

Categorical search