home page>Product Center> Card reader chip
PN5120A0HN1/C1,157
Product images are for illustrative purposes only
Product details are welcome upon request

PN5120A0HN1/C1,157

  • Category:Card reader chip
  • Product Name:Fully NFC Forum-compatible solution Highly integrated transceiver IC
  • Manufacturers:NXP
  • Production Batch Number:14+
  • Encapsulation:HVQFN32
  • Stock Status:There is stock
  • Stock Quantity:2330
  • Minimum order quantity: 1
  • Details:Click here to find PDF information PN5120A0HN1/C1,157
  • Click Request a quote
Contact usOnline customer service1 Online customer service2 Click Send email
  • Product introduction

The PN512 is a highly integrated oneTransceiver ICsfor contactless communication at 13.56 MHz. The transceiver IC utilizes an excellent modulation and demodulation concept to fully integrate a wide range of 13.56 MHz contactless communication methods and protocols.

Different versions are available

The PN512 is available in three versions:

  • PN5120A0HN1/C2 (HVQFN32) and PN5120A0HN/C2 (HVQFN40), hereinafter referred to as version 2.0
  • PN512AA0HN1/C2 (HVQFN32) and PN512AA0HN1/C2BI (HVQFN32 pre-fired), hereinafter referred to as the industrial version, comply with the AEC-Q100 Level 3 automotive certification standard developed by the Automotive Electronics Council, which defines critical stress test certification for automotive integrated circuits (ICs).
  • PN5120A0HN1/C1 (HVQFN32) and PN5120A0HN/C1 (HVQFN40), hereinafter referred to as version 1.0

Brief introduction

PN512Transceiver ICsSupports 4 different working modes:

  • Supports read-write modes for ISO/IEC 14443A/MIFARE and FeliCa schemes
  • Supports ISO/IEC 14443B read-write mode
  • Supports ISO/IEC 14443A/MIFARE and FeliCa scheme card working modes
  • NFCIP-1 mode
  • The PN512 internal transmitter has ISO/IEC 14443A/MIFARE read/write mode to drive read/write antennas and transponders without the need for additional active circuitry; The read-write antenna is designed for communication with ISO/IEC 14443A/MIFARE cards. The receiver section demodulates and decodes signals from ISO/IEC 14443A/MIFARE compliant cards and transponders in a stable and efficient manner. The digital part handles complete ISO/IEC 14443A framing and error detection (parity and CRC).

    The PN512 supports MIFARE 1K or MIFARE 4K simulation products. The PN512 supports two-way contactless communication with MIFARE's high transmission rate (up to 424 kb/s).

    The PN512 transceiver IC has a FeliCa read/write mode and supports FeliCa communication schemes. The receiver provides a stable and efficient demodulation and decoding circuit solution, compatible with FeliCa encoded signals. The digital part handles FeliCa framing and error detection, such as CRC. The PN512 supports two-way contactless communication with FeliCa's high transmission rates (up to 424 kb/s).

    PN512 supports all levels of ISO/IEC 14443B read-write communication scheme, provided that additional components (e.g., oscillators, power supplies, coils, etc.) are properly deployed and that standard protocols (e.g., ISO/IEC 14443-4 and/or ISO/IEC 14443B anti-interference) are properly deployed.

    In card operation, the PN512 transceiver IC responds to read and write commands according to the FeliCa or ISO/IEC 14443A/MIFARE card interface scheme. The PN512 generates a digital load modulation signal that, in conjunction with external circuitry, sends the response signal back to the reader. Complete security card functionality can only be provided if it is used with a security IC via the S²C interface.

    In addition, the PN512 transceiver IC communicates directly with NFCIP-1 devices in NFCIP-1 mode. NFCIP-1 mode offers a variety of communication modes and transmission rates up to 424 kb/s in accordance with Ecma 340 and ISO/IEC 18092 NFCIP-1 standards. The digital section handles complete NFCIP-1 framing and error detection.

    Integration of various host controller interfaces:

    • 8-bit parallel interface
    • SPI interface
    • Serial UART (similar to RS232, voltage level depends on pad supply voltage)
    • I²C interface.

    The purchaser of this NXP IC must have the appropriate third-party patent license.

    Features and benefits

    • Highly integrated analog circuitry for demodulating and decoding responses
    • The buffered output driver connects the antenna with the minimum number of external components
    • Integrated RF level detector
    • Integrated data pattern detector
    • Supports ISO/IEC 14443 A/MIFARE
    • Supports ISO/IEC 14443 B read/write mode
    • Typical operating distances of up to 50 mm in read-write mode depend on antenna size and tuning
    • In NFCIP-1 mode, the typical operating distance is up to 50 mm, depending on antenna size, tuning, and power supply
    • In operating mode, the typical operating distance of an ISO/IEC 14443A/MIFARE card or FeliCa card is approximately 100 mm, depending on antenna size, tuning and external field strength
    • MIFARE 1K or MIFARE 4K emulation encryption is supported in read-write mode
    • Supports ISO/IEC 14443A high communication transmission rates (212 kb/s and 424 kb/s)
    • Contactless communication according to FeliCa scheme (212 kb/s and 424 kb/s)
    • Integrated RF interface for up to 424 kb/s NFCIP-1
    • S²C interface
    • Additional power can be supplied directly to smart card ICs connected via S²C
    • Supported host interfaces:
      • SPI up to 10 Mb/s
      • I²C-bus interface (up to 400 kBd in fast mode and up to 3400 kBd in high-speed mode)
      • RS232 serial UART up to 1228.8 kBd, voltage level depends on pin supply voltage
      • Integrated/non-integrated address latch enabled 8-bit parallel interface
    • FIFO buffer, handles 64-byte send and receive
    • Flexible interrupt mode
    • Hard reset low power function
    • A shutdown mode is provided through software
    • Programmable timer
    • Internal oscillator for connection to 27.12 MHz quartz crystals
    • Supply voltage: 2.5 V to 3.6 V
    • CRC coprocessor
    • Programmable I/O pins
    • Internal self-test
  •  //www.chip100.com/

andPN5120A0HN1/C1,157Related ICs are:


Model Manufacturers lot number encapsulation illustrate
PN5120A0HN1/C1,157 NXP 14+ HVQFN32 Fully NFC Forum-compatible solution Highly integrated transceiver IC
PN5120A0HN1/C2,151 NXP 14+ HVQFN32 Fully NFC Forum-compatible solution Highly integrated transceiver IC
PN5120A0HN1/C1,151 NXP 14+ HVQFN32 Fully NFC Forum-compatible solution Highly integrated transceiver IC
PN5120A0HN1 NXP 14+ HVQFN32 Fully NFC Forum-compatible solution Highly integrated transceiver IC

Popular searches


Model Manufacturers lot number encapsulation illustrate
MIP30F00830-S1048 Amphenol Positronic 2023+ connector MIP series connectors
C163C/110EV-R1 Schaltebao 2023+ Contactors Contactors
F670-H4V-XUU LEACH 2023+ Relays F670-H4V-XUU+SHKE470-110-AD
F670-H4VP-XUXU LEACH 2023+ Relays F670-H4VP-XUXU+SFE670-1-1
AZ16-12ZI-B1-1747-M20 SCHMERSAL 2023+ switch Safety switches
RX2025GE1 Surio 2023+ connector Extract, Remove, and Insert Tools Contact extraction tool #16
5106.021.09.24 Surio 2023+ connector Extract, remove, and insert tools Extract tool with pop-up
ABMPSE06T28M4SV0N AB Connectors 2023+ connector Plug with RFI Ground
ABMPSE06T36M2SV0N AB Connectors 2023+ connector Plug with RFI Ground
ABMP18T28M13SV0N AB Connectors 2023+ connector RAIL AND MILITARY LAND SYSTEMS
ABCIRHSE06JE1812SCNF80M32V0 AB Connectors 2023+ connector Halogen Free Bayonet Lock Connector Series
TSW-101-06-LM-D samtec 2023+ connector Classic PCB Header Strips, 0.100" pitch
TNL22ERT-62 ABB 2016+ Contactors 4P St Contactor Relay 77-143Vdc |Abb TNL22ERT-62
62EM1-00001 Microchip 2023+ Development board AgileSwitch® 62mm Electrical Master SiC Gate Driver Board
E2E-X7D212-R2M Omron 2023+ sensor Standard Proximity Sensor
E2E-X7D212-R5M Omron 2023+ sensor Standard Proximity Sensor
E2E-X7D112-R5M Omron 2023+ sensor Standard Proximity Sensor
E2E-X7D112-R2M Omron 2023+ sensor Standard Proximity Sensor
E2E-X7D112-R Omron 2023+ sensor Standard Proximity Sensor
AF16ZB-30-10RT-23 ABB 2023+ Contactors Contactor 48-130V50/60HZ-DC Contactor

NXP brand product recommendation


Model Manufacturers lot number encapsulation illustrate
PN5120A0HN1/C2,151 NXP 14+ HVQFN32 Fully NFC Forum-compatible solution Highly integrated transceiver IC
PN5120A0HN1/C1,151 NXP 14+ HVQFN32 Fully NFC Forum-compatible solution Highly integrated transceiver IC
PN5120A0HN1 NXP 14+ HVQFN32 Fully NFC Forum-compatible solution Highly integrated transceiver IC
MFRC63002HN,151 NXP 15+ HVQFN32 High-performance MIFARE reader solutions
MFRC63002HN,118 NXP 15+ HVQFN32 High-performance MIFARE reader solutions
MFRC63002HN,157,157 NXP 15+ HVQFN32 High-performance MIFARE reader solutions
MFRC63002HN,157 NXP 15+ HVQFN32 High-performance MIFARE reader solutions
MFRC63002HN NXP 15+ HVQFN32 High-performance MIFARE reader solutions
MFRC53101T/0FE,112 NXP 14+ 32-Pin SO Standard ISO/IEC 14443 A/B card reader solutions
MFRC53001T/0FE,518 NXP 15+ 32-Pin SO Standard MIFARE reader solution
MFRC53001T/0FE,112 NXP 15+ 32-Pin SO Standard MIFARE reader solution
MFRC52302HN1,151 NXP 14+ HVQFN32 Standard 3V ISO/IEC 14443 A/B card reader solution
MFRC52302HN1,157 NXP 14+ HVQFN32 Standard 3V ISO/IEC 14443 A/B card reader solution
MFRC52301HN1,157 NXP 14+ HVQFN32 Standard 3V ISO/IEC 14443 A/B card reader solution
MFRC52301HN1,151 NXP 14+ HVQFN32 Standard 3V ISO/IEC 14443 A/B card reader solution
MFRC52201HN1,118 NXP 14+ HVQFN32 Standard 3V MIFARE reader solution
MFRC52201HN1,115 NXP 14+ HVQFN32 Standard 3V MIFARE reader solution
MFRC52202HN1,151 NXP 14+ HVQFN32 Standard 3V MIFARE reader solution
MFRC52202HN1,118 NXP 14+ HVQFN32 Standard 3V MIFARE reader solution
MFRC52201HN1,151 NXP 14+ HVQFN32 Standard 3V MIFARE reader solution

Categorical search