LT1212IS
Single-supply dual and quadruple precision op amps
peculiarity
- Slew rate 7V/μs typical
- Gain bandwidth product: 14MHz typical
-
Fast creation to 0.01%
2V step 200μV 900ns typical
2.2μs of 1mV typical 10V steps
-
All in package superior DC accuracy
The input offset voltage is 275μV max
The input offset voltage drifts 6μV/°
Input offset current: 30nA max
Input Bias Current: 125nA max
Open-loop gain: 1200V/mV minimum
-
Single-power operation
The input voltage range includes ground potential
The output swing is grounded while absorbing current
- Low input noise voltage: 12nV/rt Hz typical
- Low input noise current: 0.2pA/rt Hz typical
- Specified 3.3V, 5V, and ± 15V
- Large output driving current: 20mA min
- Low supply current per amplifier: 1.8 mA max
- Dual 8-pin DIP and SO8
- The quad has 14-pin DIP and narrow SO16
- Note: For applications that require high slew rates, see the LT1213/LT1214 and LT1215/LT1216 datasheets.
description
H (metal cans), J (ceramic) and K (metal cans) The software packages for Linear are obsolete
Download the detailed and complete data sheet
® The LT 1211 is a dual, single-supply precision operational amplifier with a gain bandwidth product of 14MHz and a slew rate of 7V/μs. The LT1212 is a quadruple version of the same amplifier. The DC accuracy of the LT1211/LT1212 eliminates trimming in most systems while providing high-frequency performance that would not normally be found in a single supply amplifier.
The LT1211/LT1212 will operate on any total supply greater than 2.5V and less than 36V. These amplifiers are available from a single 3.3V supply, a single 5V and ± 15V supply, specifying, requiring only a quiescent supply current of 1.3 milliamps per amplifier. There is no output of the damage or reversal stage, and the input can go beyond the supply drive. The minimum output driver is 20mA, making it ideal for driving low-impedance loads. Note: For applications that require high slew rates, see the LT1213/LT1214 and LT1215/LT1216 datasheets.