- Guaranteed monotony to 10 bits
- Low Power Operation: 156μA, max@3.3V
- Extended supply voltage range (+2.7 V to +5.5 V)
-
I 2 C-compatible 2-wire interface supporting standard (100kHz), fast (400kHz) and high-speed modes (3.4MHz)
- Rail-to-rail voltage output
- Very small package
illustrate
The DAC101C081 is a 10-bit, single-channel, voltage-output digital-to-analog converter (DAC) that operates from a +2.7 V to 5.5 V supply. The output amplifier allows rail-to-rail output swing and 6μsec resolution time. The DAC101C081 uses a supply voltage as a reference to provide the widest dynamic output range, typically consuming 132μA while operating at 5.0V. It is available in 6-pin TSOT and LLP packages and offers three address options (pin selectable).
As an alternative, the DAC101C085 offers 9 I 2 Comet treatment options and use external references. It has the same performance and settling time as the DAC101C081. It is in an 8-pin MSOP.
The DAC101C081 and DAC101C085 use 2 wires, i 2 C-compatible serial interface that operates in all three speed modes, including high-speed mode (3.4MHz). An external address select pin allows the DAC101C081 or 9 DAC101C085 to be used every 2-wire bus device. The DAC101C081 is a pin-compatible alternative that can provide additional address options.
The DAC101C081 and DAC101C085 each have a 16-bit register that controls the operating mode, power-down conditions, and output voltage. A power-on reset circuit ensures that the DAC output power is up to zero volts. Power-down function reduces power consumption by less than one microwatt. Their low power consumption and small package make these DACs an excellent choice for battery-powered devices. Each DAC operates over an extended industrial temperature range of -40°C to +125°C
The DAC101C081 and DAC101C085 are pin-compatible DACs that also offer each part of the family with 12- and 8-bit resolution. The 12-bit DAC sees the DAC121C081 and DAC121C085. The 8-bit DAC sees DAC081C081 and DAC081C085.
Main specifications
|
resolution
|
10 bits
|
|
Integral Nonlinearity (INL)
|
± 2 LSB (maximum)
|
|
DNL
|
+0.3 / -0.2 LSB (max)
|
|
Settling time
|
6 μs (max.)
|
|
Zero code errors
|
10 mV (max)
|
|
Full-scale error
|
-0.7%FS (max)
|
|
Power supply
|
|
normal
|
380μW (3V) / 730μW (5V) typical
|
|
Power down
|
0.5μW (3V) / 0.9μW (5V) typical
|
apply
- Industrial process control
- Portable instrument
- Digital gain and offset adjustment
- Programmable voltage and current sources
- Test the equipment
|