peculiarity
( VS=±15V, TA=25°C, typical).
|
Available in a space-saving 5-pin SOT-23 package
|
|
Greater than rail-to-rail input CMVR
|
- 15.3V to 15.3V
|
|
Rail-to-rail output swing
|
- 14.84V to 14.86V
|
|
Supply current
|
0.7 mA
|
|
Gain bandwidth
|
4.6 MHz
|
|
Slew rate
|
1.9 V/μs
|
|
Wide power range
|
2.7V to 32V
|
|
High power supply rejection ratio
|
106 dB
|
|
High common-mode rejection ratio
|
115 dB
|
|
Excellent buff
|
106 dB
|
|
Temperature range
|
-40°C to 125°C
|
|
Tested at -40°C, 2.7V at 125°C and 25°C, 5V at ± and 15V ±
|
illustrate
The LM7341 is a rail-to-rail input and output amplifier with a wide supply voltage and temperature range in a small SOT-23 package. The LM7341 has a 4.6 MHz gain bandwidth and a slew rate of 1.9 volts per microsecond and draws on a current supply of 0.75 mA at no load.
The LM7341 is tested at -40°C, 125°C and 25°C with modern automatic test equipment. Detailed performance specifications at 2.7V, ± 5V, ± 15V, and over a wide temperature range make the LM7341 a good choice for automotive, industrial and other demanding applications.
The rail-to-rail input common-mode range ± 15V with a minimum common-mode rejection of 76 dB, making the LM7341 a good choice for both the high and low end of remote sensing applications.
The performance of the LM7341 is consistent over a wide voltage range, and the supply voltage can be varied in applications such as automotive electrical systems and battery-powered electronics, useful parts.
The LM7341 is available in a small SOT23-5 package that takes up very little board space and can be placed close to the signal source to reduce noise pickup.
apply
- Car
- Industrial robots
- Sensor output buffer
- Multi-voltage power supply
- Reverse photodiode bias
- Low-current optocouplers
- High-side detection
- compare
- Battery charger
- Test point output buffer
- Below ground current detection