peculiarity
-
8. Horizontal equalization, 3 pin settings or via SMBus interface
-
DC-coupled inputs and outputs
-
Optimized runs from 250 Mbps to 2.25 Gbps with UXGA support for I/P, 480, 720, 1080 I/P, and 1080 P resolutions for 8, 10, and 12-bit color depth
-
Both DS16EV5110A devices support DVI/HDMI dual link
-
DVI 1.0 and HDMI 1.3a standard compatible TMDS interface
-
Clock Channel Signal Detection (LOS)
-
Enable power-saving standby mode
-
The System Management Bus (SMBus) provides boost control, output amplitude, enable, and clock channel signal detection thresholds
-
Low Power: 475mW (typical)
-
The total jitter of 0.13 UI is 1.65 Gbps including cable
-
Single 3.3V supply
-
Small 7mm x 7mm, 48-pin leadless LLP package
-
-40°C to +85°C operating temperature range
-
Extended TMDS lines reach:
-
> 40m 24 AWG DVI line (1.65Gbps)
-
> 20m 28 AWG DVI line (1.65Gbps)
-
> 20m Cat5/Cat5e/Cat6 cable (1.65Gbps)
-
> 20m 28 AWG HDMI cable (2.25Gbps)
illustrate
The DS16EV5110A is a multichannel equalizer video cable extension source/repeater/suction optimized for applications.
It operates up to 250Mbps with a rate of 1.65Gbps and 2.25Gbps (per data channel) for a common application of 2.25Gbps.
It contains three data channels for converting minimized differential signaling (TMDS) and a clock channel specified by DVI and HDMI interfaces.
Commercially available high-definition video cables provide skin effect and dielectric loss compensation when transmitting video, a common phenomenon.
The inputs meet the requirements of DVI and HDMI and feature programmable input equalization levels.
The programmable equalization level provides optimal signal enhancement and reduced inter-symbol interference.
The eight levels of improvement are either pin-selectable or optional through the system management bus interface.
The clock channel up to 225 MHz clock rate is optimized and features signal detection circuitry.
To maximize noise immunity, the DS16EV5110A features signal detection with programmable thresholds.
Adjustable thresholds via the System Management Bus (SMBus) interface.
The DS16EV5110A can be used in source applications, receive applications, or as a relay.
The DS16EV5110A also provides support system power management and enables control through outputs.
The specific application requirements for customization and optimization via SMBus require additional control.
These controls include programmable functions such as output amplitude and boost control as well as system-level diagnostics.
The DS16EV5110A is a replacement pin-to-pin DS16EV5110.
It has an enhanced CML output and exhibits high impedance when powered down.
apply
-
HDMI/DVI extension cable
-
HDMI/DVI switch
-
Projector
-
High-definition display