• Product Introduction

LT1006S8 

Precision, single-supply op-amp

peculiarity

• Single-power operation
  The input voltage range extends to the ground
  output swing while absorbing current to ground
• Guaranteed offset voltage: 50μV max
• Guaranteed low drift: 1.3μV/°C (max)
• Guaranteed offset current: 0.5nA max
• High gain guaranteed
  5 mA load current: 1.5 million minutes
  17 mA load current: 800,000 minutes
• Guaranteed low supply current: 520μA max
• The power supply current can be reduced by 4 times
• Low voltage noise, 0.1Hz to 10Hz: 0.55μVPP
  Low current noise
  Better than 10Hz ratio OP-07: 0.07pA/rtHz
• High input impedance: 250M ohmins
• Minimum supply voltage: 2.7V minimum

description

® The LT 1006 is the first precision single-supply op amp. Its design is optimized with a full set of specifications for operation on a single 5V supply. ± 15V specifications are also available.

The LT1006's 20μV low offset voltage drift of 0.2μV/°C, 120pA current cancellation, $2.5 million, 114 dB co-mode rejection and 126 dB gain from power supply suppression.

Although the supply current is only 340μA, a new output stage can exceed 20mA of source or sink while maintaining high voltage gain. The common-mode input range includes ground to accommodate low-ground reference strain gauges or thermocouple inputs with output swings of a few millivolts above the ground. If a higher slew rate (more than 1V/μs) or micro-operation (supply current reduced to 90μA) is required, the operating current can be modified to connect an optional external resistor pin8.

For similar single-supply precision dual and quad op-amps, see the LT1013/LT1014 datasheet. For micro-dual and quad op-amps, refer to the LT1078/LT1079 datasheet.