| lose enter | Pressure range | | XT | XTL/XT |
| 0.35 | 0.7 | 1.7 | 3.5 | 7 | 17 | 35 Bar |
| 5 | 10 | 25 | 50 | 100 | 250 | 500 Psi |
| Working mode | Absolute, gauge, sealed gauge, differential pressure |
| Overload pressure | 2 times the rated pressure, no change in calibration value |
| Rupture pressure | 3 times the rated pressure |
| Pressure medium | XT Series: All non-conductive, non-corrosive liquids and gases XTL Series: Anything with SiO2and 15-5PH stainless steel compatible media |
| Rated excitation voltage | 10VDC/AC |
| Maximum excitation voltage | 15VDC/AC |
| Input impedance | 1000Ω (min) |
| lose go out | Output impedance | 1000Ω (nominal) |
| Full-scale output (FSO) | 100mV (nominal) |
| Zero imbalance | ±5mV (typical) |
| Combined nonlinearity and hysteresis | 0.1% FS BFSL (typical) |
| Resolution | Infinitesimal |
| Natural frequency (kHz) (typical) | 150 | 200 | 240 | 300 | 400 | 550 | 800 |
| Acceleration sensitivity %FS/g | vertical |
1.0×10-3
| 7.0×10-4 | 3.0×10-4 | 2.0×10-4 | 8.0×10-5 | 4.0×10-5 | 2.0×10-5 |
| Transverse |
2.0×10-4
| 1.4×10-4 | 6.0×10-5 | 4.0×10-5 | 1.6×10-5 | 8.0×10-6 | 4.0×10-6 |
| Insulation resistance | ≥100MΩ at 50VDC |
| Environmental conditions | Operating temperature range | -55°C to 175°C (-65°F to 350°F) |
| Compensate for temperature range | 25°C to 80°C (80°F to 180°F) can be required in any 100°F range within the operating range |
| Hot zero point drift | ±1% FS /100°F (typical) |
| Thermally sensitive drift | ±1% FS /100°F (typical) |
| Steady-state acceleration | ≤10 000g |
| Linear vibration | 10-2000Hz sine wave, ≤100g |
| Physical properties | Electrical connection | 4 x 36AWG PTFE wires, 30 inches long |
| weight | 3 g (nominal), excluding components and connecting wires |
| Sensitivity principle | Wheatstone bridge dielectric insulated silicon stacked silicon (leadless technology XTL) |
| Installation torque | Up to 15 inches. pound |