- Ultra-low differential pressure
- Low ground pin current
- Load regulation rate 0.06%
- Quiescent current in shutdown mode of 10nA
- The guaranteed output DC current is 1.5A
- Available in TO-263, TO-220, and SOT-223 packages
- Output voltage accuracy of ± 1.5%
- Error # flag indicates the output status
- Sensing options improve load regulation
- Minimum output capacitor requirements
- Overheat/overcurrent protection
- Junction temperature range from -40°C to +125°C
illustrate
The LP3872/LP3875 series of fast ultra-low dropout linear regulators operate from +2.5 V to +7.0 V input supplies. A wide range of preset output voltages are available. These ultra-low dropout linear regulators respond very quickly to loads, which makes them suitable for low-voltage microprocessor applications. The LP3872/LP3875 is developed on the CMOS process with low quiescent current, allowing operation of output load current independent. This also allows the CMOS process to operate the LP3872/LP3875 at extremely low differential pressure conditions.
Differential pressure: ultra-low differential pressure; Typically at 150mA load current and 380mV at 1.5A load current at 38mV.
Ground pin current: Typically at 1.5A load current 6mA.
Shutdown mode: The shutdown pin is pulled down at a quiescent current of 10nA, usually at a quiescent current.
Error#Flag: When the error# flag becomes low, the output voltage drops by less than 10% of the nominal value.
SENSE: Sensor needle improvement in remote load adjustment.
High Precision Output Voltage: A wide range of output voltages are available in the range of ± 1.5% accuracy is guaranteed from 1.8V to 5.0V and ± 3.0% at room temperature, under all conditions (different lines, loads and temperatures).
apply
- Microprocessor power supply
- GTL, GTL+, BTL and SSTL bus terminals
- to DSP power supply
- SCSI terminated
- Postal Regulatory Authority
- High-efficiency linear regulator
- Battery charger
- Other battery-powered applications
|